Theft Deterrent / Keyless Entry

Power supply circuit

~1min read

DESCRIPTION

Based on changes in the power supply voltage, the main body ECU (multiplex network body ECU) can detect whether the battery has been disconnected and then reconnected.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • Before replacing the main body ECU (multiplex network body ECU), refer to the REGISTRATION section*1.

    Click here

    *1: with Smart Key System

  • Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (POWER SOURCE)

(a) Disconnect the 3F connector from the instrument panel junction block assembly.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

3F-1 - Body Ground

Always

11 à 14 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

(a) Remove the main body ECU (multiplex network body ECU).

Click here

*a

Component without wire harness connected

(instrument panel junction block assembly)

-

-

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

3F-1 - MB-31 (BECU)

Always

Below 1 Ω

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY