Theft Deterrent / Keyless Entry

Engine Room Courtesy Light Switch Circuit

~2min read

DESCRIPTION

The engine room courtesy light switch is built into the Hood Lock Assembly. This switch turns on when the hood is closed and turns off when the hood is opened.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

Before replacing the main body ECU (multiplex network body ECU), refer to the registration section (REGISTRATION). *1

Click here

  • *1: with Smart Key System

PROCEDURE

  1. READ VALUE USING TECHSTREAM (HOOD COURTESY SW)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn on the Techstream.

(d) Select the following menus: Body Electrical / Main Body / Data List.

(e) Read the Data List by following the instructions on the Techstream.

Body Electrical > Main Body > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

Hood Courtesy SW

Hood Courtesy Light Switch Assembly

ON or OFF

ON: Hood open.

OFF: Hood closed.

-

Body Electrical > Main Body > Data List

Hood Courtesy SW

OK:

The Techstream display changes correctly according to the state of the engine room courtesy light switch (Hood Lock Assembly).

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG
  1. INSPECT ENGINE ROOM COURTESY LIGHT SWITCH (HOOD LOCK ASSEMBLY)

(a) Remove the engine room courtesy light switch (Hood Lock Assembly).

Click here

(b) Inspect the engine room courtesy light switch (Hood Lock Assembly).

Click here

NG

REPLACE ENGINE ROOM COURTESY LIGHT SWITCH (HOOD LOCK ASSEMBLY)

OK
  1. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - ENGINE ROOM COURTESY LIGHT SWITCH (HOOD LOCK ASSEMBLY) - BODY GROUND)

(a) Disconnect the F15 connector from the main body ECU (multiplex network body ECU).

(b) Disconnect connector A8 from the engine room courtesy light switch (Hood Lock Assembly).

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F15-11 (HCTY) - A8-1 (+)

Always

Below 1 Ω

F15-11 (HCTY) or A8-1 (+) - Body ground

Always

10 kΩ minimum

A8-2 (E) - Body ground

Always

Below 1 Ω

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR