How to Use Troubleshooting
PRECAUTION / NOTICE / HINT
HINT:
- Follow the procedure below to troubleshoot the automatic headlight leveling system.
- *: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CONFIRMATION
|
CHECK BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard voltage:
11 à 14 V
If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.
|
INSPECT CAN COMMUNICATION SYSTEM
(a) Use the Techstream to check whether the CAN communication system is operating normally.
Click here
![]()
Result:
Result | Proceed to |
|---|---|
CAN communication system DTCs are not output |
A |
CAN communication system DTCs are output |
B |
| B | GO TO CAN COMMUNICATION SYSTEM |
|
CHECK FOR DTC* (LIGHTING SYSTEM)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn on the Techstream.
(d) Select the following menu items: Body Electrical / Main body or HL AutoLeveling / Trouble Codes.
(e) Check the DTCs.
Click here![]()
Result:
Result | Proceed to |
|---|---|
No DTCs are output |
A |
DTCs are output |
B |
| B | GO TO DIAGNOSTIC TROUBLE CODE CHART (LIGHTING SYSTEM) |
|
CHECK DTC* (AUTOMATIC HEADLIGHT LEVELING SYSTEM)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn on the Techstream.
(d) Select the following menu items: Body Electrical / HL AutoLeveling / Trouble Codes.
(e) Check the DTCs.
Click here![]()
Result:
Result | Proceed to |
|---|---|
No DTCs are output |
A |
DTCs are output |
B |
| B | GO TO DTC CHART (AUTOMATIC HEADLIGHT LEVELING SYSTEM) |
|
SYMPTOM TROUBLESHOOTING TABLE
(a) Refer to the Symptom Troubleshooting Table.
Click here![]()
Result:
Result | Proceed to |
|---|---|
The malfunction is not listed in the Problem Symptoms Table |
A |
The malfunction is listed in the Problem Symptoms Table |
B |
| B | REFER TO SYMPTOM TROUBLESHOOTING TABLE |
|
GENERAL ANALYSIS AND TROUBLESHOOTING*
(a) Data List/Active Test
Click here![]()
(b) ECU Terminals
Click here![]()
(c) Inspection
|
ADJUST, REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | END |