Exterior Lighting

Initialization not performed (B2450)

~2min read

DESCRIPTION

The left headlamp ECU subassembly stores this DTC if initialization has not been performed after ECU replacement.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Note

B2450

Initialization not performed

Left headlamp ECU subassembly initialization has not been performed

Left Headlight ECU Subassembly

-

PRECAUTION / NOTICE / HINT

NOTICE:

  • If the left headlight ECU subassembly has been replaced, it is necessary to synchronize the vehicle information and reset the left headlight ECU subassembly.

    Click here

  • If any of the following operations is performed, the left headlamp ECU subassembly must be initialized.

    Click here

    • Replacement of rear left height control sensor subassembly
    • Removal/installation of rear left height control sensor subassembly
    • Work that changes vehicle height, such as replacement of suspension components

PROCEDURE

  1. INITIALIZATION OF LEFT HEADLIGHT ECU SUB-ASSEMBLY

(a) Reset the left headlamp ECU subassembly.

Click here

NEXT
  1. CLEAR DTCs

(a) Clear the DTCs.

Click here

Body Electrical > HL AutoLeveling > Clear DTCs
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Turn the ignition switch to ON.

(b) Check DTCs.

Click here

Body Electrical > HL AutoLeveling > Trouble Codes

OK:

DTC B2450 is not output.

HINT:

If the left headlamp ECU subassembly still stores DTC B2450 after ECU initialization, there may be a malfunction in the left headlamp ECU subassembly.

OK

END (INITIALIZATION WAS NOT COMPLETED)

NG

REPLACE LEFT HEADLIGHT ECU SUBASSEMBLY