Windows

Initialization

~4min read

INITIALIZATION

INITIALIZE POWER WINDOW CONTROL SYSTEM (ALL DOORS)

NOTICE:

  • When a door window regulator subassembly, power window motor assembly, door glass or door glass run channel is reinstalled or replaced, the power window control system must be initialized. Functions such as the automatic open and close function, the anti-pinch function, the jam protection function, the remote control function, the key-linked function, the remote control transmitter-linked function, the keyless operation function and the window open warning function will not operate if initialization is not performed.
  • When the power window motor assembly is replaced, DTC B2313 is stored. Clear the DTC after initialization.

    Click here

  • Do not perform any other procedure during initialization.
  • During initialization, use the power window switch of each door to initialize each power window.
  • If initialization cannot be completed correctly, the LIN communication system may malfunction.

    Click here

  • Be sure to park the vehicle and set all electrical systems to OFF before performing initialization. Initialization will be cancelled if the vehicle is driven during initialization.
  • Be careful not to strike, knock or vibrate the door glass during initialization, as the vehicle learns the sliding resistance of the door glass.
  • Be careful not to set the ignition switch to OFF during initialization.

HINT:

When the battery is replaced, it is not necessary to initialize the power window motor assemblies.

(a) Perform initialization in accordance with the table below.

Power Window Position

Proceed to

Initialization method when a power window motor assembly has been replaced with a new part.

Procedure A

  • Initialization method to follow when a power window motor assembly has been removed/installed, or when a door glass and/or door glass run channel, etc. has been removed/installed or replaced with new parts.
  • Initialization method to use when the power window cannot be fully opened using the down function (the door glass remains visible).
  • Initialization method to use when the power window cannot be fully closed (operates erroneously in reverse) after initialization.
  • Initialization method to use when the power window cannot be fully opened (stops erroneously) after initialization.
  • Initialization method to use when instructions calling for initialization are displayed in other troubleshooting procedures.

HINT:

Follow this procedure when the power window motor assembly is to be reused.

Procedure B

Initialization method to use when the power window operates in reverse unexpectedly due to a change in sliding resistance after window glass adjustment.

Procedure C

(b) Procedure A

(1) Perform window position initialization (fully closed, fully open) and sliding resistance learning.

HINT:

*: Even if the door glass is in the fully open position before performing step 3, press and hold the switch for at least 1 second.

(c) Procedure B

(1) Reset the power window position, perform window position initialization (fully closed, fully open) and sliding resistance learning.

HINT:

  • *1: After performing step 7, release the switch, then operate the automatic open function once.
  • *2: After completing initialization, make sure the power window can be fully closed using the automatic close function.
  • If initialization cannot be completed correctly, the LIN communication system may malfunction.

    Click here

(d) Procedure C

(1) Perform sliding resistance learning.

HINT:

If the anti-pinch or jam protection function continues to operate after performing steps 4, 5 and 6, repeat the procedure from step 3.