Windows

The anti-pinch function does not operate

~2min read

DESCRIPTION

This symptom may occur for any power window.

The anti-pinch function operates within a specified range during manual or automatic closing activation.

PRECAUTION / NOTICE / HINT

NOTICE:

  • If a power window motor assembly has been replaced with a new one, initialize the power window control system.

    Click here

  • If the pulse sensor built into the power window regulator motor assemblies malfunctions, the power window control system will enter fail-safe mode. The anti-pinch function cannot be activated in fail-safe mode.

    Click here

  • After the anti-pinch function is activated during an automatic or manual close operation, the anti-pinch function will not operate if the manual close function is activated again within approximately 4 seconds.

PROCEDURE

  1. PERFORM INITIALIZATION (APPLICABLE LOCATION)

(a) Initialize the power window regulator motor assembly (applicable position).

Click here

NEXT
  1. CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION)

(a) Check whether the power window auto up and down function operates normally.

Click here

OK:

The auto up and down functions are normal.

NG

GO TO OTHER PROBLEM (go to symptom troubleshooting table)

OK
  1. CHECK THE ANTI-PINCH FUNCTION RANGE

(a) Check whether the anti-pinch function operates normally for the applicable power window.

HINT:

The anti-pinch function will not operate within 4 mm (0.157 in.) of the fully closed position.

OK:

The anti-pinch function operates normally.

Result:

Result

Proceed to

OK

A

NG (driver side power window)

B

NG (front passenger door window)

NG (rear LH side power window)

C

NG (rear RH side power window)

A

END (PROBLEM CAUSED BY INITIALIZATION FAILURE)

B

REPLACE POWER WINDOW MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR)

C

REPLACE POWER WINDOW MOTOR ASSEMBLY (FOR REAR LH DOOR OR REAR RH DOOR)