Windows
Precautions
In this manual: Windows
~2min read
PRECAUTION
IGNITION SWITCH TERMS
HINT:
The type of ignition switch used varies depending on vehicle specifications. The terms listed in the table below are used in this section.
Term | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
Ignition Switch in OFF position |
LOCK |
Off (LOCK) |
Ignition Switch in ON position |
ON |
ON (IG) |
Ignition Switch in ACC position |
ACC |
ON (ACC) |
Starting the engine |
START |
Start |
PRECAUTIONS FOR POWER WINDOW CONTROL SYSTEM
NOTICE:
- The power window control system uses the LIN communication system and the CAN communication system. Check the communication functions by following the procedure described in the How to Proceed with Troubleshooting section. Perform troubleshooting of the power window control system only after confirming that the communication system operates correctly.
Click here
.gif)
- The power window control system disables the auto-up and auto-down functions if the anti-pinch function or the anti-trap function malfunctions.
- If a power window regulator motor assembly has been replaced with a new part, initialize the power window control system.
Click here
.gif)
- If a power window regulator motor assembly and a door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly has been reused when a door window or door window guide has been replaced, initialize the power window control system.
Click here
.gif)
- The anti-pinch function or anti-trap function may activate unintentionally even when the power window control system is normal, due to a value different from the learned operating value when the door window travel speed changes suddenly under the following conditions:
- Power window opening or closing was activated while the vehicle is driving on a rough road.
- Power window opening or closing was activated while the door is opening or closing.
- The voltage changes suddenly.
- Do not disconnect the battery while the ignition switch is in the ON position. Otherwise, DTC B2313 will be stored.
Click here
.gif)
Was this page helpful?