Power Steering Assist Systems

ECU Terminals

~2min read

ECU TERMINALS

CHECK POWER STEERING ECU ASSEMBLY

*a

Component without wire harness connected

(Power Steering ECU Assembly)

-

-

(a) Measure the voltage and resistance according to the value(s) shown in the table below.

NOTICE:

When the EPS warning light comes on due to a malfunction, the fail-safe function may cause the terminals of the power steering ECU assembly to show a voltage of 0 V.

Terminal No. (Symbol)

Wire Color

Terminal Description

Condition

Specified Condition

F23-1 (IG) - Body ground

LG - Body ground

IG power supply

Ignition Switch in ON position

8 à 16 V

F23-7 (CANH) - F23-8 (CANL)

P - W

CAN communication line

Ignition Switch in OFF position

54 à 69 Ω

z3-1 (TRQ2) - z3-2 (TRQG2)

Y - G

Torque sensor 2 signal

Engine running and steering wheel not turned (no load)

2,3 à 2,7 V

Engine running and steering wheel turned to the right, vehicle stopped

1,2 à 2,5 V

Engine running and steering wheel turned to the left, vehicle stopped

2,5 à 3,8 V

z3-2 (TRQG2) - Body ground

G - Body ground

Torque sensor 2 ground

Always

Below 1 Ω

z3-3 (TRQV2) - z3-2 (TRQG2)

L - G

Torque sensor 2 voltage supply

Ignition Switch in ON position

4,5 à 5,5 V

z3-7 (TRQV1) - z3-8 (TRQG1)

R - B

Torque sensor 1 voltage supply

Ignition Switch in ON position

4,5 à 5,5 V

z3-8 (TRQG1) - Body ground

B - Body ground

Torque sensor 1 ground

Always

Below 1 Ω

z3-9 (TRQ1) - z3-8 (TRQG1)

W - B

Torque sensor signal

Engine running and steering wheel not turned (no load)

2,3 à 2,7 V

Engine running and steering wheel turned to the right, vehicle stopped

2,5 à 3,8 V

Engine running and steering wheel turned to the left, vehicle stopped

1,2 à 2,5 V

F68-1 (PIG) - Body ground

B-W - Body ground

Power source

Ignition Switch in ON position

9 à 16 V

F68-2 (PGND) - Body ground

W-B - Body ground

Power supply ground

Always

Below 1 Ω

If the result is not as specified, the ECU may be malfunctioning.