Symptom Table
SYMPTOM TROUBLESHOOTING TABLE
HINT:
- Use the table below to determine the cause of the problem symptom. If multiple suspected areas are listed, the possible causes of the symptom are shown in order of probability in the "Suspected Area" column of the table.
- Inspect each symptom by checking the suspected areas in the order listed. Replace parts as necessary.
- Check the fuses and relays associated with this system before checking the suspected areas listed below.
Symptom | Suspected Area | Link |
|---|---|---|
Steering Effort Too Heavy |
Front tires (incorrect inflation, uneven wear) |
|
Front wheel alignment (incorrect) |
||
Front suspension (lower ball joint) |
||
Steering gear assembly |
||
Battery and power source circuit |
||
Power steering ECU assembly power source voltage |
||
Power steering ECU assembly |
||
Vehicle condition (steering wheel turned from left to right several times while the vehicle is stationary, or a heavy load is continuously applied to the vehicle) |
||
Steering effort differs between right and left, or is uneven |
Rotation angle sensor initialization and torque sensor zero point calibration not completed |
|
Front tires (incorrect inflation, uneven wear) |
||
Front wheel alignment (incorrect) |
||
Front suspension (lower ball joint) |
||
Steering gear assembly |
||
Torque sensor (electric power steering column sub-assembly) |
||
Electric Power Steering Column Sub-assembly |
||
Power steering ECU assembly |
||
While driving, steering effort does not change according to vehicle speed, or the steering wheel does not return easily to the center position |
Skid control ECU (brake actuator assembly) |
|
Speed sensor |
||
Torque sensor (electric power steering column sub-assembly) |
||
Power steering ECU assembly |
||
CAN communication system |
||
Friction noise occurs when the steering wheel is turned while the vehicle is driven at low speed |
Power steering motor (power steering ECU assembly) |
|
Electric Power Steering Column Sub-assembly |
||
Spiral cable sub-assembly with sensor |
||
Steering column cover contacts steering wheel assembly |
||
A high-pitched noise (squeal) occurs when the steering wheel is turned slowly while the vehicle is stationary |
Power steering motor (power steering ECU assembly) |
|
Steering wheel installation (incorrect) |
||
The steering wheel vibrates and a noise is heard when the steering wheel is turned from lock to lock |
Power steering motor (power steering ECU assembly) |
|
Electric Power Steering Column Sub-assembly |
||
Steering wheel installation (incorrect) |
||
DTCs cannot be output (TC and CG terminals of DLC3 are connected) |
TC and CG terminal circuit |
|
IG power supply circuit |
||
Meter / Gauge System |
||
EPS warning light remains on |
EPS warning light circuit |