Power Steering Assist Systems

Freeze Frame Data

~8min read
0102030405000N·mlb·ft
Tightening torque found on this page

FREEZE FRAME DATA

FREEZE FRAME DATA

NOTICE:

  • It is difficult to clearly specify the values (judgment values), because the freeze frame data values change significantly due to differences in measurement conditions, environment, or vehicle conditions. For this reason, a problem may occur even when the values are within specification.
  • Turn the ignition switch to ON, then park the vehicle on level ground. Check the freeze frame data using the Techstream.

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn on the Techstream.

(e) Check the freeze frame data on the Techstream.

Chassis > EMPS

Tester display

Item

Range

Normal Condition

Diagnostic Note

Meter Vehicle Velocity

Speedometer vehicle speed

Min.: 0 km/h

Max.: 300 km/h

  • 0 km/h: engine running and vehicle stationary
  • No significant change: Engine running and vehicle moving at constant speed

-

Wheel Speed Right

Right rear wheel rotation speed

Min.: 0 km/h

Max.: 255 km/h

  • 0 km/h: engine running and vehicle stationary
  • No significant change: Engine running and vehicle moving at constant speed

-

Wheel Speed Left

Left rear wheel rotation speed

Min.: 0 km/h

Max.: 255 km/h

  • 0 km/h: engine running and vehicle stationary
  • No significant change: Engine running and vehicle moving at constant speed

-

Engine Revolution

Engine speed

Min.: 0 rpm

Max.: 12,800 rpm

No significant change

Engine runs at constant speed

Motor Actual Current

Amount of current supplied to the motor

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

- Value increases when turning left and decreases when turning right

Engine running and steering wheel turned

Command Value Current

Current required to the motor

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

- Value increases when turning left and decreases when turning right

Engine running and steering wheel turned

Steering Angle Velocity

Steering angle speed

Min.: -32,768 deg/s

Max.: 32,767 deg/s

Value changes in proportion to steering speed

- Value increases when turning left and decreases when turning right

Engine running and steering wheel turned

Thermistor Temperature

ECU board temperature

Min.: -50.0 °C

Max.: 150 °C

-50°C à 150 °C

-

IG Power Supply

IG power supply voltage

Min.: 0.0000 V

Max.: 20.1531 V

8 à 16 V

Ignition Switch in ON position

Steering Wheel Torque

Steering wheel torque

Min.: -7.0 N·m

Max.: 7 N·m

Value changes in proportion to steering effort

- Value increases when turning left and decreases when turning right

Engine running and steering wheel turned

Motor Rotation Angle

Motor rotation angle

Min.: 0.000 deg.

Max.: 360.000 deg.

Motor rotation angle varies from 0 to 360° during steering operation

Engine running and steering wheel turned

Command Val Current 2

Current required to the motor

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

Engine running and steering wheel turned

Motor Voltage

Motor power supply voltage

Min.: 0.000 V

Max.: 98.000 V

  • Approx. 27 V: Engine running and steering wheel turned
  • Approx. 27 to 34 V: Engine running and steering wheel not turned

-

TRQ1 Zero Point Value

Torque sensor 1 zero point value

Min.: 0.0000 V

Max.: 4.9725 V

2,3 à 2,7 V

Engine running and steering wheel not turned (no load)

TRQ2 Zero Point Value

Torque sensor 2 zero point value

Min.: 0.0000 V

Max.: 4.9725 V

2,3 à 2,7 V

Engine running and steering wheel not turned (no load)

PS Assist Signal

Power steering assist signal recording status

OFF or ON

OFF: Ignition switch in ON position

ON: Engine running

-

Motor Actual Current 2

Amount of current supplied to the motor

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

Engine running and steering wheel turned

Stop&Start Ctrl Mode

Stop & start control mode recording status

IG, Run, Stopreq, Stop, Restart

IG: Ignition switch in ON position (before engine start)

Run: Engine running

Stopreq: Engine stop request

Stop: Engine stopped

Restart: Engine restart

-

Steering Angle

Steering angle

Min.: -3,072.0 deg.

Max.: 3,070.5 deg.

-

-

Torque Sensor 1 Output

Torque sensor 1 output value

Min.: 0.0000 V

Max.: 4.9725 V

-

-

Torque Sensor 2 Output

Torque sensor 2 output value

Min.: 0.0000 V

Max.: 4.9725 V

-

-

Torque Sensor 1 Power Supply

Torque sensor 1 power supply voltage

Min.: 0.0000 V

Max.: 4.9725 V

-

-

Torque Sensor 2 Power Supply

Torque sensor 2 power supply voltage

Min.: 0.0000 V

Max.: 4.9725 V

-

-

Rotation Angle Sensor Output 1

Rotation angle sensor output voltage Vx1

Min.: 0.0000 V

Max.: 4.9725 V

-

-

Rotation Angle Sensor Output 2

Rotation angle sensor output voltage Vx2

Min.: 0.0000 V

Max.: 4.9725 V

-

-

Rotation Angle Sensor Output 3

Rotation Angle Sensor Output Voltage Vy1

Min.: 0.0000 V

Max.: 4.9725 V

-

-

Rotation Angle Sensor Output 4

Rotation Angle Sensor Output Voltage Vy2

Min.: 0.0000 V

Max.: 4.9725 V

-

-

Motor 1 Terminal Current (U)

Motor 1 Terminal Current (U Phase)

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

Engine running and steering wheel turned

Motor 1 Terminal Current (V)

Motor 1 Terminal Current (V Phase)

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

Engine running and steering wheel turned

Motor 1 Terminal Current (W)

Motor 1 Terminal Current (W Phase)

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

Engine running and steering wheel turned

Motor 2 Terminal Current (U)

Motor 2 Terminal Current (U Phase)

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

Engine running and steering wheel turned

Motor 2 Terminal Current (V)

Motor 2 Terminal Current (V Phase)

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

Engine running and steering wheel turned

Motor 2 Terminal Current (W)

Motor 2 Terminal Current (W Phase)

Min.: -327.68 A

Max.: 327.67 A

Value changes in proportion to steering effort

Engine running and steering wheel turned

Motor 1 U Phase Duty

Motor 1 U Phase Duty

Min.: 0.00 %

Max.: 100.00 %

-

-

Motor 1 V Phase Duty

Motor 1 V Phase Duty

Min.: 0.00 %

Max.: 100.00 %

-

-

Motor 1 W Phase Duty

Motor 1 W Phase Duty

Min.: 0.00 %

Max.: 100.00 %

-

-

Motor 2 U Phase Duty

Motor 2 U Phase Duty

Min.: 0.00 %

Max.: 100.00 %

-

-

Motor 2 V Phase Duty

Motor 2 V Phase Duty

Min.: 0.00 %

Max.: 100.00 %

-

-

Motor 2 W Phase Duty

Motor 2 W Phase Duty

Min.: 0.00 %

Max.: 100.00 %

-

-

Motor 1 Terminal Voltage (U)

Motor 1 Terminal Voltage (U Phase)

Min.: 0.000 V

Max.: 98.000 V

Value varies in the range of 4 to 35 V

Engine running and steering wheel turned

Motor 1 Terminal Voltage (V)

Motor 1 Terminal Voltage (V Phase)

Min.: 0.000 V

Max.: 98.000 V

Value varies in the range of 4 to 35 V

Engine running and steering wheel turned

Motor 1 Terminal Voltage (W)

Motor 1 Terminal Voltage (W Phase)

Min.: 0.000 V

Max.: 98.000 V

Value varies in the range of 4 to 35 V

Engine running and steering wheel turned

Motor 2 Terminal Voltage (U)

Motor 2 Terminal Voltage (U Phase)

Min.: 0.000 V

Max.: 98.000 V

Value varies in the range of 4 to 35 V

Engine running and steering wheel turned

Motor 2 Terminal Voltage (V)

Motor 2 Terminal Voltage (V Phase)

Min.: 0.000 V

Max.: 98.000 V

Value varies in the range of 4 to 35 V

Engine running and steering wheel turned

Motor 2 Terminal Voltage (W)

Motor 2 Terminal Voltage (W Phase)

Min.: 0.000 V

Max.: 98.000 V

Value varies in the range of 4 to 35 V

Engine running and steering wheel turned

Motor 1 PIG Power Supply

Power supply voltage for driving Motor 1

Min.: 0.0000 V

Max.: 20.1531 V

9 à 16 V

Engine running and steering wheel turned

Motor 2 PIG Power Supply

Power supply voltage for driving Motor 2

Min.: 0.0000 V

Max.: 20.1531 V

9 à 16 V

Engine running and steering wheel turned