Power Steering Assist Systems

Vehicle Speed Signal (C1541)

~2min read

DESCRIPTION

The EPS ECU assembly receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication. Based on these signals, the ECU provides the appropriate assist force according to vehicle speed.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Warning indicated

Return to normal state

Note

C1541

Vehicle speed signal

The vehicle speed signals via the CAN communication system are interrupted for at least 3 seconds.

  • Brake Control System
  • CAN communication system
  • Power steering ECU assembly

EPS warning light comes on

The ECU determines that the system has returned to normal, or the ignition switch is turned to ON

-

PRECAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform the assist card writing and the torque sensor zero point calibration.

Click here

PROCEDURE

  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check whether DTC U0129 is output.

Click here

Result:

Result

Proceed to

DTC U0129 is not output.

A

DTC U0129 is output.

B

B

PROCEED TO CAN COMMUNICATION SYSTEM (HOW TO USE TROUBLESHOOTING)

A
  1. CHECK BRAKE CONTROL SYSTEM

(a) Using the Techstream, check the DTCs and confirm that the brake control system has no malfunction.

Click here

Chassis > ABS/VSC/TRAC > Trouble Codes

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

A

REPLACE EPS ECU ASSEMBLY

B

PROCEED TO BRAKE CONTROL SYSTEM (DTC CHART)