Power Steering Assist Systems

EPS warning light circuit

~2min read

DESCRIPTION

If the EPS ECU assembly detects a malfunction, it stores a DTC and illuminates the EPS warning light.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • If the power steering ECU assembly has been replaced, perform the assist card writing and the torque sensor zero point calibration.

    Click here

  • Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR

(a) Lightly shake the EPS ECU assembly connectors and wire harness up and down and side to side, and check the illumination condition of the EPS warning light in the combination meter assembly.

OK:

The illumination condition of the EPS warning light does not change.

HINT:

When the EPS warning light operates normally, it illuminates when the ignition switch is turned ON and turns off after the engine is started.

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check the DTCs.

Click here

Result:

Result

Proceed to

No CAN communication system DTCs are output.

A

CAN communication system DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK HARNESS AND CONNECTOR (IG POWER SOURCE - GROUND)

(a) Disconnect connectors F68 and F23 from the EPS ECU assembly.

*a

Front view of wire harness side connector

(to EPS ECU assembly)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F23-1 (IG) - Body ground

Ignition Switch in ON position

8 à 16 V

F68-1 (PIG) - Body ground

Ignition Switch in ON position

9 à 16 V

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F68-2 (PGND) - Body ground

Always

Below 1 Ω

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK COMBINATION METER ASSEMBLY

(a) Connect connectors F68 and F23 of the EPS ECU assembly.

(b) Perform the Active Test of the combination meter assembly using the Techstream.

Body Electrical > Combination Meter > Active Test

EPS Indicator

(c) Check the combination meter assembly.

OK:

The EPS warning light illuminates and turns off in accordance with Techstream operation.

OK

REPLACE EPS ECU ASSEMBLY

NG

GO TO METER/GAUGE SYSTEM