Power Steering Assist Systems

IG Power Source Voltage (C1551)

~2min read

DESCRIPTION

The EPS ECU assembly distinguishes between the ON and OFF state of the ignition switch through the IG power source circuit.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Warning indicated

Return to normal state

Note

C1551

IG power supply voltage

Open or short circuit in the IG power supply circuit with the ignition switch in the ON (IG) position

  • EPS-IG1 Fuse
  • IG power supply circuit
  • Power steering ECU assembly

EPS warning light comes on

The ECU determines that the system has returned to normal, or the ignition switch is turned to ON

-

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • If the power steering ECU assembly has been replaced, perform the assist card writing and the torque sensor zero point calibration.

    Click here

  • Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (BATTERY - EPS ECU ASSEMBLY)

(a) Disconnect connectors F68 and F23 from the EPS ECU assembly.

*a

Front view of wire harness side connector

(to EPS ECU assembly)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F23-1 (IG) - Body ground

Ignition Switch in ON position

8 à 16 V

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F68-2 (PGND) - Body ground

Always

Below 1 Ω

OK

REPLACE EPS ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR