Power Steering Assist Systems

ECU Matching Error (C1567)

~1min read

DESCRIPTION

Based on the steering angle sensor signal, the EPS ECU assembly determines whether the type of steering angle sensor installed is correct.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Warning indicated

Return to normal state

Note

C1567

ECU matching error

There is an error in the recognition system

  • Steering Angle Sensor (Incorrect Part Number)
  • Power steering ECU assembly

EPS warning light comes on

Ignition switch turned to ON again

-

PRECAUTION / NOTICE / HINT

NOTICE:

When the EPS ECU assembly has been replaced, perform assist map writing, steering angle sensor initialization, and torque sensor zero point calibration.

Click here

PROCEDURE

  1. CHECK STEERING ANGLE SENSOR

(a) Make sure that the steering angle sensor matches the vehicle specifications.

Click here

OK:

A steering angle sensor that matches the vehicle specifications is installed.

NOTICE:

When removing an applicable part to perform the check, be sure to follow the appropriate procedures and precautions.

HINT:

If DTC C1567 is output and the parts have not been replaced, replace the EPS ECU assembly, as it may have an internal malfunction.

OK

REPLACE EPS ECU ASSEMBLY

NG

REPLACE STEERING ANGLE SENSOR