How to Use Troubleshooting
PRECAUTION / NOTICE / HINT
HINT:
- Follow these procedures to troubleshoot the power steering system.
- *: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CHECK BATTERY
(a) Turn the ignition switch OFF.
(b) Measure the battery voltage.
Standard voltage:
11 à 14 V
HINT:
If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.
|
CHECK DTCs AND FREEZE FRAME DATA*
HINT:
Refer to Check / Clear DTCs.
Click here
![]()
|
CONFIRM PROBLEM SYMPTOMS
Result:
Result | Proceed to |
|---|---|
The symptom does not occur. |
A |
The symptom occurs. |
B |
| B | GO TO STEP 6 |
|
SIMULATE SYMPTOMS
|
CHECK CAN COMMUNICATION SYSTEM*
(a) Check the DTCs.
Click here
![]()
Result:
Result | Proceed to |
|---|---|
No CAN communication system DTCs are output. |
A |
CAN communication system DTCs are output. |
B |
HINT:
- If CAN communication system DTCs are output, first perform troubleshooting for the CAN communication system.
- If communication with the power steering ECU assembly cannot be established using the Techstream, check the CANH and CANL terminals of the DLC3 and the power steering ECU assembly, and check the IG circuit of the power steering ECU assembly.
| B | GO TO CAN COMMUNICATION SYSTEM |
|
CHECK DTCs*
(a) Check the DTCs.
Click here
![]()
HINT:
Refer to the diagnostic trouble code chart when DTCs are output.
Click here
![]()
Result:
Result | Proceed to |
|---|---|
No DTCs are output. |
A |
DTCs are output. |
B |
| B | GO TO STEP 10 |
|
SYMPTOM TROUBLESHOOTING TABLE
(a) Refer to the Symptom Troubleshooting Table.
Click here![]()
Result:
Result | Proceed to |
|---|---|
The malfunction is not listed in the Symptom Troubleshooting Table. |
A |
The malfunction is listed in the Symptom Troubleshooting Table. |
B |
| B | GO TO STEP 10 |
|
GENERAL ANALYSIS AND TROUBLESHOOTING*
(a) Refer to the ECU terminals.
Click here![]()
(b) Refer to Data List / Active Test.
Click here![]()
|
REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | END |