Precautions
PRECAUTION
IGNITION SWITCH TERMS
HINT:
The type of ignition switch used varies depending on vehicle specifications. The terms listed in the table below are used in this section.
Term | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
Ignition Switch in OFF position |
LOCK |
OFF (Locked) |
Ignition Switch in ACC position |
ACC |
ON (ACC) |
Ignition Switch in ON position |
ON |
ON (IG) |
Starting the engine |
START |
ON (Starting) |
PRECAUTIONS FOR REMOVAL, INSTALLATION AND REPLACEMENT OF ELECTRONIC POWER STEERING COMPONENTS
(a) Be sure to keep the front wheels straight when removing and installing the steering gear assembly.
(b) When disconnecting the steering intermediate shaft assembly, be sure to place alignment marks before starting any work.
(c) After replacing the steering column assembly or the power supply assembly of the power steering ECU assembly, perform the torque sensor zero point calibration.
Click here![]()
HANDLING PRECAUTIONS
(a) When handling electronic components:
(1) Do not subject any parts such as ECUs and relays to impact. Replace with new parts if dropped or subjected to a severe impact.
(2) Do not expose electronic components to high temperatures or humidity.
(3) To prevent deformation or malfunctions caused by static electricity, do not touch the connector terminals.
(b) When handling the power steering ECU assembly:
(1) When the power steering ECU assembly has been replaced, perform the assist map writing and the torque sensor zero point calibration.
Click here![]()
(c) When handling the electric power steering column sub-assembly:
(1) Do not subject the electric power steering column sub-assembly (especially the motor and torque sensor) to impact. Replace the electric power steering column sub-assembly with a new one if it has been subjected to a severe impact.
(2) Do not pull on the wire harness when moving the electric power steering column sub-assembly.
(3) When the electric power steering column sub-assembly has been replaced, perform torque sensor zero point calibration.
Click here![]()
(d) When disconnecting and reconnecting connectors:
(1) Before disconnecting the connectors related to the power steering system, turn the ignition switch to ON, center the steering wheel, turn the ignition switch to OFF, then disconnect the connectors.
(2) Before reconnecting the connectors related to the power steering system, make sure the ignition switch is OFF. Then center the steering wheel and turn the ignition switch to ON.
NOTICE:
Do not turn the ignition switch to ON if the steering wheel is not centered.
(3) If the above operations are not performed correctly, the steering center point (zero point) may deviate from its correct value, which may result in a difference in steering effort between right and left turns. If there is a difference in steering effort between right and left turns, perform torque sensor zero point calibration after initializing the torque sensor zero point.
Click here![]()
PRECAUTIONS FOR CAN COMMUNICATION
(a) The CAN communication lines are used to receive information from the skid control ECU (brake actuator assembly) and the ECM, and to transmit warnings to the combination meter assembly. When problems are detected in the CAN communication lines, CAN communication DTCs are stored.
(b) If CAN communication system DTCs are output, first perform troubleshooting for the CAN communication system.
(c) The wiring used for each communication line is a twisted pair of wires of equal length. Do not temporarily repair the CAN communication line using a bypass wire or equivalent.