Power Steering Assist Systems

Assist Map Not Written (C1581)

~3min read

DESCRIPTION

This DTC is recorded if the EPS ECU assembly determines that the assist map has not been written to the ECU.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Warning indicated

Return to normal state

Note

C1581

Assist card number not written

The assist card is not written in the power steering ECU assembly

  • CAN communication system
  • ECM
  • Main body ECU (multiplex network body ECU)
  • Skid control ECU (brake actuator assembly)
  • Power steering ECU assembly

EPS warning light comes on

Assist card writing is performed, or the ignition switch is turned to ON

-

PRECAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform the assist card writing and the torque sensor zero point calibration.

Click here

HINT:

Registration information of the affected parts required for assist card writing.

Affected part:

  • ECM
  • Main body ECU (multiplex network body ECU)
  • Skid control ECU (brake actuator assembly)

PROCEDURE

  1. PERFORM ASSIST MAP WRITING

(a) Perform assist map writing.

Click here

Chassis > EMPS > Utility

Signal Check

(b) Check DTCs.

Click here

Chassis > EMPS > Trouble Codes

Result:

Result

Proceed to

DTC C1581 is output.

A

DTC C1581 is not output.

B

NOTICE:

DTC C1581 is cleared after assist map writing.

B

END

A
  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check the DTCs.

Click here

Result:

Result

Proceed to

No CAN communication system DTCs are output.

A

CAN communication system DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK THE CORRESPONDING PARTS

(a) Check whether the applicable part has the correct part number.

Applicable part

ECM

Main body ECU (multiplex network body ECU)

Skid control ECU (brake actuator assembly)

NOTICE:

When removing the applicable part to perform the check, be sure to follow the appropriate procedures and precautions.

  • ECM

    Click here

  • Main body ECU (multiplex network body ECU)

    Click here

  • Skid control ECU (brake actuator assembly)

Result:

Result

Proceed to

The applicable part has the correct part number.

A

The applicable part has an incorrect part number.

B

B

GO TO STEP 5

A
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Select the status check mode on the Techstream screen and check whether the system DTCs of the applicable part are output.

HINT:

If the system DTCs of the applicable part are recorded, assist map writing to the EPS ECU assembly cannot be performed correctly.

Result:

Result

Proceed to

System DTCs of the applicable part are output.

A

System DTCs of the applicable part are not output.

B

A

REPAIR CIRCUIT INDICATED BY OUTPUT CODE

B

REPLACE EPS ECU ASSEMBLY

  1. REPLACE APPLICABLE PART WITH ONE THAT HAS THE CORRECT PART NUMBER

(a) Replace the applicable part with one that has the correct part number.

  • ECM

    Click here

  • Main body ECU (multiplex network body ECU)

    Click here

  • Skid control ECU (brake actuator assembly)
NEXT
  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Check the DTCs.

Click here

Chassis > EMPS > Trouble Codes

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

A

END

B

REPLACE EPS ECU ASSEMBLY