Power Steering Assist Systems

PIG Power Source Voltage (C1552,C1554)

~2min read

DESCRIPTION

If a problem occurs in the system, the power source relay circuit and the motor relay circuit are cut off to stop power steering assist. The ECU must be replaced if there is a problem with the relays, because the relays are built into the ECU.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

Warning indicated

Return to normal state

Note

C1552

PIG power supply voltage

PIG power supply circuit malfunction

  • EPS Fuse
  • PIG Power Source Circuit
  • Power steering ECU assembly

EPS warning light comes on

Ignition switch turned to ON again

-

C1554

Power supply relay failure

Malfunction in the power supply source relay circuit

  • EPS Fuse
  • PIG Power Source Circuit
  • Power steering ECU assembly

EPS warning light comes on

Ignition switch turned to ON again

-

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • If the power steering ECU assembly has been replaced, perform the assist card writing and the torque sensor zero point calibration.

    Click here

  • Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK WIRE HARNESS AND CONNECTOR (EPS ECU ASSEMBLY - BODY GROUND)

(a) Disconnect the EPS ECU assembly F68 connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F68-1 (PIG) - Body ground

Ignition Switch in ON position

9 à 16 V

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F68-2 (PGND) - Body ground

Always

Below 1 Ω

*a

Front view of wire harness side connector

(to EPS ECU assembly)

OK

REPLACE EPS ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR