Power Steering Assist Systems

TC and CG terminal circuit

~3min read
1special tools

DESCRIPTION

Connecting the TC and CG terminals of the DLC3 causes the ECU to display DTCs by flashing the EPS warning light.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform the assist card writing and the torque sensor zero point calibration.

Click here

HINT:

If the warning light continues to flash, there may be a short to ground in the wiring of the DLC3 TC terminal, or an internal short to ground in one or more ECUs.

PROCEDURE

  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check the DTCs.

Click here

Result:

Result

Proceed to

No CAN communication system DTCs are output.

A

CAN communication system DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DLC3

(a) Turn the ignition switch to ON.

*a

Front view of DLC3

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F41-13 (TC) - F41-4 (CG)

Ignition Switch in ON position

9 à 16 V

NG

GO TO STEP 4

OK
  1. REPLACE ECU

(a) Turn the ignition switch OFF.

*a

Front view of DLC3

(b) Replace the ECM.

Click here

(c) Using SST, connect the TC and CG terminals of the DLC3.

SST: 09843-18040

(d) Check that the EPS warning light flashes.

OK:

The EPS warning light flashes.

HINT:

If troubleshooting was performed in accordance with the symptom troubleshooting table, refer to the table and proceed to the next step before replacing the part.

Click here

OK

END

NG

REPLACE EPS ECU ASSEMBLY

  1. CHECK HARNESS AND CONNECTOR (DLC3 TC - ECM)

(a) Disconnect ECM connector A38.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F41-13 (TC) - A38-33 (TC)

Always

Below 1 Ω

F41-13 (TC) or A38-33 (TC) - Body Ground

Always

10 kΩ minimum

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK HARNESS AND CONNECTOR (DLC3 CG - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F41-4 (CG) - Body Ground

Always

Below 1 Ω

HINT:

If troubleshooting was performed in accordance with the symptom troubleshooting table, refer to the table and proceed to the next step before replacing the part.

Click here

*a

Front view of DLC3

NG

REPAIR OR REPLACE HARNESS AND CONNECTOR OR EACH ECU

OK
  1. REPLACE ECU

(a) Replace the ECM.

*a

Front view of DLC3

(b) Using SST, connect the TC and CG terminals of the DLC3.

Click here

SST: 09843-18040

(c) Check that the EPS warning light flashes.

OK:

The EPS warning light flashes.

HINT:

If troubleshooting was performed in accordance with the symptom troubleshooting table, refer to the table and proceed to the next step before replacing the part.

Click here

OK

END

NG

REPLACE EPS ECU ASSEMBLY