Power Steering Assist Systems

Calibration

~3min read

CALIBRATION

TORQUE SENSOR ZERO POINT CALIBRATION (USING TECHSTREAM)

NOTICE:

Perform torque sensor zero point calibration if any of the following occurs:

  • The power steering ECU assembly has been replaced.
  • The electric power steering column sub-assembly has been replaced.
  • There is an imbalance in steering effort between the left and right sides.

(a) Perform the pre-calibration check.

(1) Turn the ignition switch OFF.

(2) Connect the Techstream to the DLC3.

(3) Turn the ignition switch to the ON position.

(4) Turn on the Techstream.

(5) Calibrate the power steering ECU assembly. Select the following menu items: Chassis / EMPS / Data List.

(6) Check the values by referring to the table below.

Chassis > EMPS > Data List

Tester display

Item

Range

Normal Condition

Diagnostic Note

IG Power Supply

IG power supply voltage

Min.: 0.0000 V

Max.: 20.1531 V

8 à 16 V

Ignition Switch in ON position

Chassis > EMPS > Data List

IG Power Supply

Standard voltage:

8 à 16 V

NOTICE:

If the IG power supply voltage is 8 V or lower, calibration cannot be performed. In this case, charge or replace the battery, then perform calibration.

(b) Perform torque sensor zero point calibration.

NOTICE:

If DTC C1516 (torque sensor zero point adjustment incomplete) is stored, the torque sensor zero point cannot be calibrated. Clear the DTCs before starting calibration.

(1) Align the front wheels straight ahead and set the steering wheel to the centered position.

(2) Turn the ignition switch OFF.

(3) Connect the Techstream to the DLC3.

(4) Turn the ignition switch ON.

(5) Turn on the Techstream.

(6) Select the following menu items: Chassis / EMPS / Utility / Torque Sensor Adjustment.

Chassis > EMPS > Utility

Torque Sensor Adjustment

NOTICE:

  • Do not turn the steering wheel too hard.
  • During torque sensor zero point calibration, the steering wheel will vibrate. Do not touch the steering wheel until at least 3 seconds have passed after the vibration has stopped.

(7) Check the DTCs.

Click here

Chassis > EMPS > Trouble Codes

NOTICE:

If DTC C1515, C1516, C1534 or C1581 is output, perform troubleshooting for the corresponding DTC.

Result:

Result

See procedure

DTC C1515 is output.

DTC C1516 is output.

DTC C1534 is output.

DTC C1581 is output.

WRITING ASSIST MAP (USING TECHSTREAM)

NOTICE:

Write the assist map when the following condition occurs:

The power steering ECU assembly has been replaced.

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn on the Techstream.

(e) Select the following menu items: Chassis / EMPS / Utility / Signal Check.

Chassis > EMPS > Utility

Signal Check

HINT:

  • Follow the instructions displayed on the Techstream to perform a signal check.
  • If DTC C1581 is output, the signal check will switch the power steering ECU assembly to signal check mode and automatically write the assist map.

(f) Wait for at least 5 seconds.

(g) Check the DTCs.

Click here

Chassis > EMPS > Trouble Codes

HINT:

After writing the assist map, if DTC C1581 is output, perform the troubleshooting procedure for DTC C1581.

Click here