Tire Pressure Monitoring

ECU Terminals

~3min read

ECU TERMINALS

TIRE PRESSURE DETECTION ECU AND RECEIVER

(a) Disconnect connector M23 from the tire pressure warning ECU and receiver, then measure the voltage or resistance on the wire harness side.

*a

Front view of wire harness side connector

(to tire pressure warning ECU and receiver)

Terminal No. (Symbol)

Wire Color

Terminal Description

Condition

Specified Condition

M23-1 (IG) - M23-12 (GND)

SB - W-B

IG power supply

Ignition Switch in ON position

10 à 16 V

M23-7 (+B) - M23-12 (GND)

R - W-B (*1)

B - W-B (*2)

Power source (from battery)

Always

10 à 16 V

M23-12 (GND) - Body ground

W-B - Body ground

Ground

Always

Below 1 Ω

  • *1: without smart key system
  • *2: with Smart Key System

(b) Connect connector M23 to the tire pressure warning ECU and receiver.

(c) Measure the voltage and resistance according to the value(s) shown in the table below. If the result does not meet the specifications, there may be a malfunction in the ECU.

HINT:

Measure the values on the wire harness side with the connector connected.

*a

Component with Wire Harness Connected

(tire pressure warning ECU and receiver)

-

-

Terminal No. (Symbol)

Wire Color

Terminal Description

Condition

Specified Condition

M23-3 (CLSW) - M23-12 (GND)

Y - W-B

Tire Pressure Reset Switch

  • Ignition Switch in ON position
  • Steering pad switch assembly operated, "TPMS" selected on the multi-information display, and "ENTER" switch (steering pad switch assembly) pressed and held in this position

Below 1.5 V

  • Ignition Switch in ON position
  • "ENTER" switch (steering pad switch assembly) in the OFF position

8 à 15 V

M23-4 (RDA) - M23-12 (GND)

G - W-B

Output signals

Ignition Switch in ON position

Pulse generation (see waveform 1)

M23-5 (PRG) - M23-12 (GND)

W - W-B

Input signals

Ignition Switch in ON position

Pulse generation (see waveform 1)

(d) Check waveform 1 using an oscilloscope.

*a

Example

*b

GND

Waveform 1:

Item

Content

Terminal

M23-4 (RDA) - M23-12 (GND)

M23-5 (PRG) - M23-12 (GND)

Oscilloscope Setting

5 V/DIV., 5 ms/DIV.

Vehicle Operating Conditions

Ignition Switch in ON position

HINT:

The waveform shown in the illustration is an example. If the tester displays a waveform that alternates between high and low levels, with the high level between the IG power supply voltage and 2.2 V below it, and the low level between 0 and 1.2 V, the ECU can be considered normal.