Tire Pressure Monitoring

How to Use Troubleshooting

~3min read

PRECAUTION / NOTICE / HINT

HINT:

  • Follow the procedure below to troubleshoot the tire pressure monitoring system.
  • Make sure the remote control of the door lock system is out of diagnostic mode before performing the following procedure.
  • *: Use the Techstream.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CUSTOMER PROBLEM ANALYSIS

(a) Ask the customer to confirm the problem.

HINT:

It is important to gather as much specific information as possible from the customer to allow a quick repair.

NEXT
  1. ADJUST TIRE PRESSURE*

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Select the following menus: Chassis / Tire Pressure Monitor / Data List.

Click here

(e) Adjust the pressure of all tires to the specified value.

NOTICE:

Refer to the link, as the tire pressure adjustment procedure varies depending on tire temperature.

Click here

(f) Display "ID Tire Inflation Pressure" in the Data List and make sure the tire pressure values match the adjusted pressure.

HINT:

It may take a few minutes for the values to be displayed.

(g) Perform initialization.

Click here

HINT:

The tire pressure monitoring system turns on the low tire pressure warning light to warn the driver when the following condition is met:

  • When the steering wheel switch assembly is operated, the tire pressure decreases to approximately 75% or less of the tire pressure setting at the time of system initialization.

Result:

Result

Proceed to

The low tire pressure warning light stays on

A

The low tire pressure warning light turns off

B

B

GO TO STEP 11

A
  1. CHECK ECUS CONNECTED TO CAN BUS*

(a) Check the ECUs connected to the CAN bus.

Click here

Result:

Result

Proceed to

No malfunction is displayed

A

A malfunction occurs

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DTCs (CAN COMMUNICATION SYSTEM)*

(a) Check the DTCs.

Click here

Result:

Result

Proceed to

No CAN system DTCs are output

A

CAN system DTCs are output

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DTCs*

(a) Check the DTCs.

Click here

Result:

Result

Proceed to

DTCs are output

A

No DTCs are output

B

B

GO TO STEP 8

A
  1. DTC CHART

(a) Refer to the DTC Chart.

Click here

NEXT

GO TO STEP 10

  1. SYMPTOM TROUBLESHOOTING TABLE

(a) Refer to the Symptom Troubleshooting Table.

Click here

NEXT
  1. CIRCUIT INSPECTION*

(a) Refer to the electronic circuit inspection procedure.

Click here

NEXT
  1. REPAIR OR REPLACE

(a) Repair or replace parts based on the diagnostic result.

NEXT
  1. CONFIRMATION TEST*

(a) Check the Data List to confirm that the tire inflation pressure has been received.

Click here

(b) Perform initialization.

Click here

(c) Confirm that initialization is complete.

NEXT

END