Diagnostic System
DIAGNOSTIC SYSTEM
CHECK MODE
NOTICE:
- If there is a problem with the tire pressure detection system, the tire pressure warning light flashes at 0.5-second intervals and stays on after 1 minute.
- Once the malfunction has been corrected, the tire pressure warning light turns off.
- When the tire pressure warning light comes on, check the tire pressure immediately and adjust it to the specified value.
- When the ignition switch is turned to the ON position, the tire pressure warning light comes on for 3 seconds, then turns off. If the light does not come on for 3 seconds, troubleshoot the tire pressure warning light circuit.
Click here
.gif)
(a) Turn the ignition switch to ON.
*1 |
Low tire pressure warning light |
(b) Make sure the tire pressure warning light comes on for 3 seconds.
WHAT TO CONSIDER WHEN THE TIRE PRESSURE WARNING LIGHT COMES ON
(a) If the tire pressure warning light does not turn off or comes on while driving, check the tire pressure. If the light comes on several hours after adjusting the tire pressure, the tire may have a slow air leak.
(b) The system is deactivated under the following conditions (the system operates normally once the normal condition is restored).
(1) When all tire and wheel assemblies, with the tire valves and transmitters registered in the tire pressure warning ECU and receiver, have not been reinstalled.
(2) When the transmitter ID codes are not registered in the tire pressure warning ECU and receiver.
(3) When the tire pressure is relatively high (absolute pressure: 480 kPa (4.9 kgf/cm2, 70 psi) minimum; gauge pressure: 380 kPa (3.9 kgf/cm2, 55 psi) minimum).
(4) When the tire valve transmitter battery is discharged (battery life is 10 years).
(c) The system is deactivated under the following conditions (the system operates normally once the normal condition is restored).
(1) When electrical equipment or devices using similar radio frequencies are nearby.
(2) When a wireless device or other equipment using a similar frequency is used inside the vehicle.
(3) If a tint that may affect radio wave signals is applied.
(4) If there is a large amount of snow or ice on the vehicle, particularly around the wheels or wheel housings.
(5) If non-genuine wheels are used.
(6) If snow chains are used.
(7) If aftermarket tire repair sealant has been used.
CAUTION:
- Do not use a tire pressure valve and transmitter that have tire sealant on them.
*a
Tire sealant
- The measurement port of the tire pressure valve and transmitter may become blocked, preventing accurate measurement of air pressure and preventing the system from operating correctly.
LOW TIRE PRESSURE WARNING LIGHT AND INDICATOR TABLE
HINT:
The table below shows the status of the low tire pressure warning light once the ignition switch is turned to ON.
Immediately after turning the ignition switch to ON | Always |
||||
|---|---|---|---|---|---|
Warning light display sequence |
|||||
Lights up for 3 s | Turns off | Comes on | Flashes | DTCs Output |
|
Normal |
○ |
○ |
- |
- |
- |
Low tire pressure |
○ |
- |
○ |
- |
- |
System malfunction |
○ |
- |
- |
*1 |
- |
Test mode (signal check mode) |
○ |
- |
- |
*2 |
- |
Initialization |
○ |
- |
- |
*3 |
- |
ECU connector improperly connected |
- |
- |
- |
*4 |
- |
TC grounded (DTC output) |
○ |
- |
- |
- |
○ |
TC grounded (DTC not output) |
○ |
- |
- |
*5 |
- |
- *1: Blinks at 0.5-second intervals and stays on after 1 minute.
*a
ON
*b
OFF
*c
0,5 s
*d
1 minute
- *2: Blinks at 0.125-second intervals.
*a
ON
*b
OFF
*c
0,125 s
- *3: Blinks 3 times at 1-second intervals.
*a
ON
*b
OFF
*c
1 s
- *4: Turns off for 10 seconds to check the ECU connector connection, then blinks at 0.5-second intervals and stays on after 1 minute.
*a
ON
*b
OFF
*c
0,5 s
*d
1 minute
*e
10 s
- *5: Blinks at 0.25-second intervals.
*a
ON
*b
OFF
*c
0,25 s
NORMAL MODE DTCs
(a) DTCs are stored in the tire pressure warning ECU and receiver and are output by flashing the tire pressure warning light or by using the Techstream.
Click here![]()
TEST MODE (SIGNAL CHECK MODE) DTCs
(a) When switching from normal mode to test mode (signal check mode), the tire pressure warning ECU and receiver, each tire pressure valve and transmitter, and the low tire pressure reset switch can be checked.
Click here![]()