Tire Pressure Monitoring

ECU Power Supply Circuit

~1min read

DESCRIPTION

This is the power supply to the tire pressure warning ECU and receiver.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • When replacing the tire pressure warning ECU and receiver, record the IDs stored in the ECU using the Techstream and note them down before removal.

    Click here

  • Initialization is necessaryafter registeringof the transmitter IDs in the tire pressure warning ECU after replacing the ECU.

HINT:

Check the fuses for the circuits related to this system before performing the following inspection procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (ECU - BATTERY AND BODY GROUND)

(a) Disconnect the M23 tire pressure ECU and receiver connector.

*a

Front view of wire harness side connector

(to tire pressure warning ECU and receiver)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

M23-1 (IG) - Body Ground

Ignition Switch in ON position

10 à 16 V

Ignition Switch in OFF position

Below 1 V

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

M23-12 (GND) - Body ground

Always

Below 1 Ω

OK

REPLACE TIRE PRESSURE ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR