Tire Pressure Monitoring

Precautions

~4min read

PRECAUTION

IGNITION SWITCH TERMS

(a) The type of ignition switch used varies depending on vehicle specifications. The terms listed in the table below are used in this section.

Term

Ignition Switch (Position)

Engine Switch (Condition)

Ignition Switch in OFF position

LOCK

OFF

Ignition Switch in ON position

ON

ON (IG)

Ignition Switch in ACC position

ACC

ON (ACC)

Starting the engine

START

Start

TIRE PRESSURE WARNING ECU AND RECEIVER TERMS

(a) The type of tire pressure warning ECU and receiver used on this model varies depending on vehicle specifications. The terms listed in the table below are used in this section.

Vehicle Specifications

Part Reference in Manual

Actual Part Reference

with Smart Key System

Tire pressure warning ECU and receiver

Electronic Key Receiver & Tire Pressure Warning ECU Assembly

without Smart Key System

Door control receiver and tire pressure warning system receiver assembly.

CAUTIONS FOR TIRE PRESSURE WARNING SYSTEM

(a) Tire inflation pressure naturally decreases over time, which also occurs on vehicle models not equipped with a tire pressure warning system.

HINT:

Tire pressure decreases by approximately 5 kPa (0.05 kgf/cm², 0.7 psi) to 10 kPa (0.1 kgf/cm², 1.5 psi) per month.

(b) It is necessary to adjust the tire pressure periodically because it naturally decreases over time.

(c) In winter, tire pressure may decrease due to low ambient temperatures (tire pressure decreases by approximately 10 kPa (0.1 kgf/cm², 1.5 psi) for every drop in ambient temperature of 10 °C). Therefore, the tire pressure warning system may illuminate a warning if the tire pressure is not adjusted properly. If the daily temperature varies greatly, add enough pressure to the tires to compensate for the cold. This should reduce the risk of unnecessary tire pressure warning system operation.

(d) Always use a new grommet and valve core when installing a tire pressure valve and transmitter to ensure the performance of the sealant.

(e) When replacing one or more tire pressure valves, transmitters, or the tire pressure warning ECU and receiver, the transmitter IDs of all tire pressure valves and transmitters must be re-registered. Before registering the transmitter ID of a new tire pressure valve and transmitter, check the data list and record all transmitter IDs that are already registered.

(f) Use only a specified valve cap. If a cap that does not meet specifications is used, it may seize to the tire pressure valve and transmitter.

(g) Depending on the tire type, the system may not operate correctly even when the specified wheels are used.

(h) To prevent damage to the tire pressure valve and transmitter, make sure the tire pressure valve and transmitter do not interfere with the tire bead when installing or removing a tire.

(i) To prevent damage to the tire pressure valve and transmitter, drop the tire pressure valve and transmitter into the wheel before releasing the tire bead or removing the tire from the wheel.

PROCEDURES REQUIRED WHEN REPLACING PARTS

(a) ID Registration

When replacing the tire pressure warning valve and transmitter, or the tire pressure warning ECU and receiver, register the ID of the tire pressure warning valve and transmitter.

Click here

(b) Initialization

After registering the ID of the tire pressure warning valve and transmitter, be sure to initialize the tire pressure warning system.

Click here