Tire Pressure Monitoring

Tire pressure warning light circuit

~3min read

DESCRIPTION

If the tire pressure warning ECU and receiver detect a problem, the tire pressure warning light flashes (stays on after flashing for 1 minute) and the tire pressure monitoring function is canceled at the same time. At this point, the ECU stores a DTC in memory.

Connect the TC and CG terminals of the DLC3 to flash the tire pressure warning light and output the DTC.

The tire pressure warning ECU and receiver send a warning light request signal to the main body ECU (multiplex body ECU) via a dedicated line. The main body ECU (multiplex body ECU) then sends the signal to the instrument cluster assembly via the CAN communication system.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • When replacing the tire pressure warning ECU and receiver, record the IDs stored in the ECU using the Techstream and note them down before removal.

    Click here

  • Initialization must be performedafter registeringthe transmitter IDs in the tire pressure ECU if the ECU and/or any of the valves and transmitters have been replaced.

PROCEDURE

  1. CHECK DTCs (CAN COMMUNICATION SYSTEM)

(a) Check whether CAN communication system DTCs are output.

Click here

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DTC OUTPUT (B1247)

(a) Clear the DTCs.

Click here

Chassis > Tire Pressure Monitor > Clear DTCs

(b) Turn the ignition switch OFF.

(c) Turn the ignition switch to ON.

(d) Check the DTCs.

Click here

Chassis > Tire Pressure Monitor > Trouble Codes

OK:

DTC B1247 is not output.

NG

GO TO DTC (B1247)

OK
  1. CHECK TIRE PRESSURE WARNING LIGHT OPERATION (ACTIVE TEST)

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn on the Techstream.

(e) Select the following menu items: Body Electrical / Combination Meter / Active Test.

(f) Check the tire pressure warning light status using the Techstream.

Body Electrical > Combination Meter > Active Test

Tester display

Item

Control Range

Diagnostic Note

Tire Pressure Warning System Indicator

Low tire pressure warning light

OFF or ON

Perform the test with the vehicle stationary and the engine idling.

Body Electrical > Combination Meter > Active Test

Tire Pressure Warning System Indicator

OK:

The tire pressure warning light turns on and off according to the Techstream operation.

OK

REPLACE TIRE PRESSURE ECU AND RECEIVER

NG

GO TO METER/GAUGE SYSTEM