Tire Pressure Monitoring
Receiver Malfunction (C2176/76)
In this manual: Tire Pressure Monitoring
~1min read
DESCRIPTION
The measured values are transmitted to the tire pressure warning ECU and the transmitter inside the vehicle in the form of radio waves.
DTC No. | Detection Item | DTC Detection Condition | Suspected Area | Note |
|---|---|---|---|---|
C2176/76 |
Receiver Error |
Malfunction in the internal circuit of the tire pressure warning ECU and receiver. |
Tire pressure warning ECU and receiver |
- |
PRECAUTION / NOTICE / HINT
NOTICE:
- When replacing the tire pressure warning ECU and receiver, record the IDs stored in the ECU using the Techstream and note them down before removal.
- Initialization must be performed
after registering
the transmitter IDs in the tire pressure ECU if the ECU and/or any of the valves and transmitters have been replaced.
PROCEDURE
CHECK OUTPUT DTC (C2176/76)
(a) Clear the DTCs.
Click here![]()
(b) Turn the ignition switch OFF.
(c) Turn the ignition switch to ON and check the DTCs.
Click here![]()
OK:
DTC C2176/76 is not output.
| OK | END |
| NG | REPLACE TIRE PRESSURE ECU AND RECEIVER |
Was this page helpful?