Tire Pressure Monitoring

TC and CG terminal circuit

~2min read

DESCRIPTION

DTC output mode is selected by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are displayed by flashing the tire pressure warning light.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • When replacing the tire pressure warning ECU and receiver, record the IDs stored in the ECU using the Techstream and note them down before removal.

    Click here

  • Initialization is necessaryafter registeringof the transmitter IDs in the tire pressure warning ECU after replacing the ECU.

PROCEDURE

  1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check whether a CAN communication system DTC is output.

Click here

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK DTCs (C2179/79)

(a) Check whether DTC C2179/79 is output.

Click here

Chassis > Tire Pressure Monitor > Trouble Codes

Result:

Result

Proceed to

DTC C2179/79 is not output.

A

DTC C2179/79 is output.

B

B

GO TO DTC C2179/79

A
  1. CHECK HARNESS AND CONNECTOR (DLC3 TC - ECM)

(a) Disconnect ECM connector A38.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F41-13 (TC) - A38-33 (TC)

Always

Below 1 Ω

F41-13 (TC) or A38-33 (TC) - Body Ground

Always

10 kΩ minimum

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK HARNESS AND CONNECTOR (DLC3 CG - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F41-4 (CG) - Body Ground

Always

Below 1 Ω

*a

Front view of DLC3

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK DLC3 TERMINAL VOLTAGE (TC VOLTAGE)

(a) Reconnect the A38 ECM connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F41-13 (TC) - F41-4 (CG)

Ignition Switch in ON position

11 à 14 V

*a

Front view of DLC3

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG

REPLACE ECM