Preventive Action

Steering angle sensor (C1A47)

~3min read

DESCRIPTION

The millimeter wave radar sensor assembly receives steering angle information from the steering angle sensor (spiral cable with sensor assembly). If the millimeter wave radar sensor assembly detects a malfunction in the steering angle sensor (spiral cable with sensor assembly), DTC C1A47 is stored.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1A47

Steering angle sensor

While the vehicle is driving at a speed of 50 km/h or more, the millimeter wave radar sensor assembly continuously receives a steering angle sensor (spiral cable with sensor assembly) malfunction signal for at least 0.8 seconds.

  • Vehicle Stability Control System
  • Skid control ECU (brake actuator assembly)
  • Millimeter wave radar sensor assembly

PRECAUTION / NOTICE / HINT

NOTICE:

  • When replacing the millimeter wave radar sensor assembly, always replace it with a new one.
  • When the millimeter wave radar sensor assembly is replaced with a new one, the radar sensor beam axis must be adjusted.

    Click here

  • The Pre-Collision System uses the CAN communication system. First, make sure there are no malfunctions in the CAN communication system. Refer to How to Use Troubleshooting.

    Click here

PROCEDURE

  1. CHECK DTCs (VEHICLE STABILITY CONTROL SYSTEM)

HINT:

The Pre-Collision Safety System DTC C1A47 may be stored due to a malfunction in the VSC system. Therefore, check and perform troubleshooting of the VSC system DTCs first.

(a) Check the DTCs.

Click here

Chassis > ABS/VSC/TRAC/EPB > Trouble Codes

Result:

Result

Proceed to

VSC-related DTCs are not output

A

VSC-related DTCs are output

B

B

GO TO VEHICLE STABILITY CONTROL SYSTEM

A
  1. READ DTCs (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Clear DTCs

(b) Make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system is unable to detect malfunctions.

(c) Check the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Trouble Codes

Result:

Result

Proceed to

DTC C1A47 is not output

A

DTC C1A47 is output

B

A

USE SIMULATION METHOD TO CHECK

B
  1. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Replace the millimeter wave radar sensor assembly.

Click here

(b) Adjust the millimeter wave radar sensor assembly.

Click here

NEXT
  1. READ DTCs (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Clear DTCs

(b) Make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system is unable to detect malfunctions.

(c) Check the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Trouble Codes

Result:

Result

Proceed to

DTC C1A47 is not output

A

DTC C1A47 is output

B

A

END (MILLIMETER WAVE RADAR SENSOR ASSY WAS MALFUNCTIONING)

B

REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)