Preventive Action

Diagnostic System

~2min read

DIAGNOSTIC SYSTEM

CHECK DLC3

(a) Check DLC3.

Click here

INDICATOR AND WARNING MESSAGE FUNCTION

(a) If the Pre-Collision System does not operate properly, the driver is alerted by the PCS indicator and a warning message is displayed on the multi-information display.

Warning message

Details

DTC

PCS light

"Pre-Collision System Malfunction Visit Your Dealer"

Pre-Collision System malfunction

Registered

Flashes

"Pre-Collision System Unavailable"

Millimeter wave radar sensor assembly is not aligned

Not registered

Illuminated

"Pre-Collision System Unavailable Clean Sensor"

A foreign object is attached to the millimeter wave radar sensor assembly

Not registered

Illuminated

"Front Camera Unavailable"

  • Forward recognition camera abnormal voltage
  • Forward recognition camera temperature outside operating range

Not registered

Comes on

The message "Front Camera Vision Blocked. Clean and Demist Windshield"

A foreign object is attached to the forward recognition camera or to the windshield area in front of the forward recognition camera

Not registered

Comes on

"VSC Turned Off Pre-Collision Brake System Unavailable"

VSC system is turned off

Not registered

Comes on

PCS indicator illumination status

PCS light

Condition

Flashes

ON: 0.5 s / OFF: 1.5 s

Pre-Collision System malfunction (DTC stored)

Illuminated

Pre-Collision System temporarily disabled

Pre-Collision System disabled

VSC system disabled

Off

Other

INITIAL CHECK

(a) An initial check is performed when the ignition switch is kept in the OFF position for more than 2 seconds and then turned to ON. The initial check is a diagnostic check of the Pre-Collision System and takes approximately 3 seconds.

(b) If a malfunction is detected during the initial check, the PCS indicator on the combination meter assembly illuminates and a warning message indicating that the Pre-Collision System is malfunctioning or disabled is displayed on the multi-information display.

CONTINUOUS CHECK

(a) After the ignition switch is turned to ON and the initial check (approximately 3 seconds) is complete, the millimeter wave radar sensor assembly continuously monitors the Pre-Collision System for malfunctions.

(b) If a malfunction is detected during the continuous check, the PCS indicator on the combination meter assembly illuminates and a warning message indicating that the Pre-Collision System is malfunctioning or disabled is displayed on the multi-information display.