Preventive Action

Utility

~3min read

UTILITY

NOTICE:

If the millimeter wave radar sensor assembly is replaced, replace it with a new one.

If the millimeter wave radar sensor assembly has been replaced or removed and installed, be sure to perform the front beam axis adjustment. If this is not done, DTC C1A14 will be stored when the system is turned ON.

Control Mode

HINT:

  • This mode is used to check the operation of the Pre-Collision System by reproducing situations in which the Pre-Collision System has operated unnecessarily.
  • If the Pre-Collision Assist Control or Pre-Collision Braking Control is activated while reproducing the symptoms of the problem, a dangerous situation may occur. To prevent this, do not operate the Pre-Collision Braking Control. When reproducing the symptoms of the problem, operate only the Pre-Collision Warning Control (buzzer and warning message).

    Pre-Collision Control Activated

    Buzzer signal

    Pre-Collision Warning Control

    Intermittent (Long)

    Pre-Collision Assist Control

    Intermittent (Short)

    Pre-Collision Braking Control

    Always

(a) Connect the Techstream to the DLC3.

(b) Select the following menu items: Body Electrical / Pre-Collision 2 / Utility / Control Mode.

(c) Perform the control mode according to the values displayed on the Techstream.

Body Electrical > Pre-Collision 2 > Utility

Control Mode

Front Beam Axis Adjustment

HINT:

The front beam axis of the millimeter wave radar sensor assembly is adjusted using the Techstream.

(a) Connect the Techstream to the DLC3.

(b) Select the following menu items: Body Electrical / Pre-Collision 2 / Utility / Front Beam Axis Adjustment.

(c) Perform the front beam axis adjustment according to the display on the Techstream.

Click here

Body Electrical > Pre-Collision 2 > Utility

Front Beam Axis Adjustment

Front Beam Axis Misalignment Value

HINT:

The misalignment of the millimeter wave radar sensor assembly can be checked using the Techstream.

(a) Connect the Techstream to the DLC3.

(b) Select the following menu items: Body Electrical / Pre-Collision 2 / Utility / Front Beam Axis Misalignment Reading.

(c) Read the front beam axis misalignment according to the display on the Techstream.

Click here

Body Electrical > Pre-Collision 2 > Utility

Front Beam Axis Misalignment Reading

Front Beam Axis Offset Value

HINT:

The offset of the millimeter wave radar sensor assembly can be checked using the Techstream.

(a) Connect the Techstream to the DLC3.

(b) Select the following menu items: Body Electrical / Pre-Collision 2 / Utility / Front Beam Axis Offset Reading.

(c) Read the front beam axis offset according to the display on the Techstream.

Click here

Body Electrical > Pre-Collision 2 > Utility

Front Beam Axis Offset Reading

History Clear

HINT:

If the history data status is "ON", clear the corresponding data.

(a) Connect the Techstream to the DLC3.

(b) Select the following menu items: Body Electrical / Pre-Collision 2 / Utility / History Clear.

(c) Clear the history according to the display on the Techstream.

Body Electrical > Pre-Collision 2 > Utility

History Clear