Preventive Action

ECU Power Supply Circuit

~2min read

DESCRIPTION

This circuit supplies the power required by the millimeter wave radar sensor assembly when the ignition switch is in the ON position.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

Check the fuses for the circuits related to this system before performing the following inspection procedure.

PROCEDURE

  1. INSPECT MILLIMETER WAVE RADAR SENSOR ASSEMBLY (IGB VOLTAGE)

(a) Disconnect the millimeter wave radar sensor assembly connector.

*a

Front view of wire harness side connector

(to millimeter wave radar sensor assembly)

(b) Turn the ignition switch to ON.

(c) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Ignition switch position

Specified Condition

A2-8 (IGB) - Body ground

Ignition Switch in ON position

11 à 14 V

(d) Turn the ignition switch to OFF.

(e) Reconnect the millimeter wave radar sensor assembly connector.

NG

REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

OK
  1. CHECK WIRE HARNESS AND CONNECTOR (MILLIMETER WAVE RADAR SENSOR ASSEMBLY - BODY GROUND)

(a) Disconnect the millimeter wave radar sensor assembly connector.

*a

Front view of wire harness side connector

(to millimeter wave radar sensor assembly)

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

A2-1 (SGND) - Body ground

Always

Below 1 Ω

(c) Connect the millimeter wave radar sensor assembly connector.

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR