Preventive Action

Front Camera Module Circuit (C1AA0)

~3min read

DESCRIPTION

The millimeter wave radar sensor assembly receives information from the front recognition camera about the area in front of the vehicle.

If the millimeter wave radar sensor assembly detects a malfunction in the front recognition camera, it sets DTC C1AA0.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1AA0

Front camera module circuit

While the ignition switch is ON, the forward recognition camera detects an internal malfunction for at least approximately 0.3 seconds.

  • Forward Recognition Camera System
  • Front Area Recognition Camera
  • Millimeter wave radar sensor assembly

PRECAUTION / NOTICE / HINT

NOTICE:

  • When replacing the millimeter wave radar sensor assembly, always replace it with a new one.
  • When the millimeter wave radar sensor assembly is replaced with a new one, the radar sensor beam axis must be adjusted.

    Click here

  • If the forward recognition camera has been replaced with a new one, be sure to perform the forward recognition camera axis adjustment.

    Click here

  • The Pre-Collision System uses the CAN communication system. First, make sure there are no malfunctions in the CAN communication system. Refer to How to Use Troubleshooting.

    Click here

PROCEDURE

  1. CHECK WHETHER DTCs ARE OUTPUT (FORWARD RECOGNITION CAMERA SYSTEM)

HINT:

DTC C1AA0 related to the pre-collision safety system may be set due to a malfunction in the front recognition camera system. Therefore, it is necessary to check and troubleshoot the DTCs related to the forward recognition camera system first.

(a) Check the DTCs.

Click here

Chassis > Front Recognition Camera > Trouble Codes

Result:

Result

Proceed to

DTCs of the forward recognition camera system are not output

A

DTCs of the forward recognition camera system are output.

B

B

GO TO FORWARD RECOGNITION CAMERA SYSTEM

A
  1. READ DTCs (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Clear DTCs

(b) Make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system is unable to detect malfunctions.

(c) Check the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Trouble Codes

Result:

Result

Proceed to

DTC C1AA0 is not output

A

DTC C1AA0 is output

B

A

USE SIMULATION METHOD TO CHECK

B
  1. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Replace the millimeter wave radar sensor assembly.

Click here

(b) Adjust the millimeter wave radar sensor assembly.

Click here

NEXT
  1. READ DTCs (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Clear DTCs

(b) Make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system is unable to detect malfunctions.

(c) Check the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Trouble Codes

Result:

Result

Proceed to

DTC C1AA0 is not output

A

DTC C1AA0 is output

B

A

END (MILLIMETER WAVE RADAR SENSOR ASSY WAS MALFUNCTIONING)

B

REPLACE FORWARD RECOGNITION CAMERA