Symptom Table
SYMPTOM TROUBLESHOOTING TABLE
HINT:
- Use the table below to determine the cause of the symptoms. If several suspected areas are listed, the possible causes of the symptom are shown in order of probability in the "Suspected Area" column of the table. Check each symptom, verifying the suspected areas in the order listed. Replace parts if necessary.
- Check the fuses and relays associated with this system before checking the suspected areas listed below.
- The Pre-Collision System uses the CAN communication system. First, make sure there are no malfunctions in the CAN communication system. Refer to How to Use Troubleshooting.
Symptom | Suspected Area | Link |
|---|---|---|
The "Pre-Collision System Unavailable" message is displayed |
Perform millimeter wave radar sensor assembly adjustment*1 |
|
Millimeter wave radar sensor assembly |
||
Combination meter assembly |
||
The "Pre-Collision System Unavailable Clean Sensor" message is displayed |
A foreign object is attached to the millimeter wave radar sensor assembly |
- |
Millimeter wave radar sensor assembly |
||
Combination meter assembly |
||
"Front Camera Unavailable" is displayed |
Front Area Recognition Camera |
|
Combination meter assembly |
||
Millimeter wave radar sensor assembly |
||
The "Front Camera Vision Blocked. Clean and Demist Windshield" message is displayed |
A foreign object is attached to the forward recognition camera or to the windshield area in front of the forward recognition camera |
- |
Front Area Recognition Camera |
||
Combination meter assembly |
||
Millimeter wave radar sensor assembly |
||
Although there is a possibility of collision, the Pre-Collision System controls (all controls) do not operate (the "Pre-Collision System Unavailable" message is not displayed) |
Check whether the Pre-Collision System is turned off |
- |
The vehicle condition/environment does not meet the Pre-Collision System operating conditions (check the control operating conditions). |
||
Check the installation condition of the millimeter wave radar sensor assembly |
||
Perform millimeter wave radar sensor assembly adjustment |
||
Millimeter wave radar sensor assembly |
||
Check the installation condition of the forward recognition camera |
||
Perform forward recognition camera adjustment |
||
Front Area Recognition Camera |
||
Although there is no possibility of collision, the Pre-Collision System controls (all controls) operate |
The vehicle condition/environment does not meet the Pre-Collision System operating conditions (check the control operating conditions). |
|
Check the installation condition of the millimeter wave radar sensor assembly |
||
Perform millimeter wave radar sensor assembly adjustment |
||
Millimeter wave radar sensor assembly |
||
Check the installation condition of the forward recognition camera |
||
Perform forward recognition camera adjustment |
||
Front Area Recognition Camera |
||
The Pre-Collision System does not operate |
Check whether the Pre-Collision System is turned off |
- |
ECU Power Supply Circuit |
||
Millimeter wave radar sensor assembly |
||
The Pre-Collision System cannot be turned off (PCS indicator does not illuminate) |
Combination meter assembly (check whether the indicator illuminates using Active Test) |
|
Millimeter wave radar sensor assembly |
||
Check steering wheel switch assembly condition |
||
Combination meter assembly |
||
Cannot change the Pre-Collision System warning timing (warning timing setting screen is not displayed on the multi-information display) |
Millimeter wave radar sensor assembly |
|
Combination meter assembly |
*1: If error code 7 is output during beam axis alignment, clear the DTCs and perform beam axis alignment again
.gif)