Preventive Action

Brake System Malfunction (C1A50)

~3min read

DESCRIPTION

When the pre-collision safety system is operating, the millimeter wave radar sensor assembly sends brake control signals to the skid control ECU (brake actuator assembly).

When the millimeter wave radar sensor assembly receives a VSC system malfunction signal from the skid control ECU (brake actuator assembly) via CAN communication, DTC C1A50 is set.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

C1A50

Brake system malfunction

With the ignition switch ON, the millimeter wave radar sensor assembly receives a VSC system malfunction signal from the skid control ECU (brake actuator assembly) for at least 0.3 seconds.

  • Vehicle Stability Control System
  • Skid control ECU (brake actuator assembly)
  • Millimeter wave radar sensor assembly

PRECAUTION / NOTICE / HINT

NOTICE:

  • When replacing the millimeter wave radar sensor assembly, always replace it with a new one.
  • When the millimeter wave radar sensor assembly is replaced with a new one, the radar sensor beam axis must be adjusted.

    Click here

  • The Pre-Collision System uses the CAN communication system. First, make sure there are no malfunctions in the CAN communication system. Refer to How to Use Troubleshooting.

    Click here

PROCEDURE

  1. CHECK DTCs (VEHICLE STABILITY CONTROL SYSTEM)

HINT:

The pre-collision safety system DTC C1A50 may be set due to a VSC system malfunction. Therefore, it is necessary to check and troubleshoot the VSC system DTCs first.

(a) Check the DTCs.

Click here

Chassis > ABS/VSC/TRAC/EPB > Trouble Codes

Result:

Result

Proceed to

VSC-related DTCs are not output

A

VSC-related DTCs are output

B

B

GO TO VEHICLE STABILITY CONTROL SYSTEM

A
  1. READ DTCs (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Clear DTCs

(b) Make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system is unable to detect malfunctions.

(c) Check the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Trouble Codes

Result:

Result

Proceed to

DTC C1A50 is not output

A

DTC C1A50 is output

B

A

USE SIMULATION METHOD TO CHECK

B
  1. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

(a) Replace the millimeter wave radar sensor assembly.

Click here

(b) Adjust the millimeter wave radar sensor assembly.

Click here

NEXT
  1. READ DTCs (PRE-COLLISION SYSTEM)

(a) Clear the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Clear DTCs

(b) Make sure the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system is unable to detect malfunctions.

(c) Check the DTCs.

Click here

Body Electrical > Pre-Collision 2 > Trouble Codes

Result:

Result

Proceed to

DTC C1A50 is not output

A

DTC C1A50 is output

B

A

END (MILLIMETER WAVE RADAR SENSOR ASSY WAS MALFUNCTIONING)

B

REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)