Heater / Air Conditioning

IG power supply circuit

~1min read

DESCRIPTION

The power supply voltage supplies the air conditioning amplifier assembly when the ignition switch is ON. This power supply is used to operate the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. INSPECT WIRE HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - IG+ POWER SOURCE)

(a) Disconnect the connector from the air conditioning amplifier assembly.

*a

Front view of wire harness side connector

(to A/C amplifier assembly)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Ignition switch position

Specified Condition

F72-5 (IG+) - Body ground

Ignition Switch in OFF position

Below 1 V

F72-5 (IG+) - Body ground

Ignition Switch in ON position

11 à 14 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. CHECK WIRE HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F72-29 (GND) - Body ground

Always

Below 1 Ω

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR