Automatic High Beam Switch Circuit
DESCRIPTION
The Main Body ECU (Multiplex Network Body ECU) detects automatic high beam switch signals. The automatic high beam system can be turned on or off using the Instrument Panel & Integration Control Assembly (Automatic High Beam Switch).
WIRING DIAGRAM
PRECAUTION / NOTICE / HINT
NOTICE:
Before replacing the main body ECU (multiplex network body ECU), refer to the registration section.*1
- *1: with Smart Key System
PROCEDURE
READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn on the Techstream.
(d) Select the following menus: Body Electrical / Main Body / Data List.
(e) Read the Data List by following the instructions on the Techstream.
Body Electrical > Main Body > Data ListTester display | Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
Auto High Beam Main Switch |
Auto High Beam Switch Signal |
ON or OFF |
ON: Auto high beam switch pressed OFF: Auto high beam switch released |
- |
Auto High Beam Main Switch
OK:
The normal conditions listed above are displayed.
| OK | GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE |
|
CHECK AUTOMATIC HIGH BEAM SWITCH
(a) Remove the automatic high beam switch.
Click here![]()
(b) Check the automatic high beam switch.
Click here![]()
OK:
The automatic high beam switch is normal.
| NG | REPLACE AUTOMATIC HIGH BEAM SWITCH |
|
CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND BODY GROUND)
(a) Disconnect the F15 connector from the main body ECU (multiplex network body ECU).
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
F6-6 (+B) - F15-17 (AHBI) |
Always |
Below 1 Ω |
F6-6 (+B) or F15-17 (AHBI) - Body ground |
Always |
10 kΩ minimum |
F6-3 (E) - Body ground |
Always |
Below 1 Ω |
| OK | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |