How to Use Troubleshooting
PRECAUTION / NOTICE / HINT
HINT:
- Follow the procedure below to troubleshoot the Automatic High Beam system.
- *: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CONFIRMATION
|
CHECK BATTERY VOLTAGE
(a) Measure the battery voltage.
Standard voltage:
11 à 14 V
If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.
|
CHECK CAN COMMUNICATION SYSTEM*
(a) Use the Techstream to check whether the CAN communication system is operating normally.
Click here
![]()
Result:
Result | Proceed to |
|---|---|
CAN communication system DTCs are not output |
A |
CAN communication system DTCs are output |
B |
| B | GO TO CAN COMMUNICATION SYSTEM |
|
CHECK DTCs*
(a) Check the DTCs.
Click here![]()
Result:
Result | Proceed to |
|---|---|
No DTCs are output |
A |
DTCs are output |
B |
| B | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
SYMPTOM TROUBLESHOOTING TABLE
(a) Refer to the Symptom Troubleshooting Table.
Click here![]()
Result:
Result | Proceed to |
|---|---|
The malfunction is not listed in the Problem Symptoms Table |
A |
The malfunction is listed in the Problem Symptoms Table |
B |
| B | REFER TO SYMPTOM TROUBLESHOOTING TABLE |
|
GENERAL ANALYSIS AND TROUBLESHOOTING*
(a) Data List/Active Test
Click here![]()
(b) ECU Terminals
Click here![]()
(c) Inspection
|
ADJUST, REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | END |