Exterior Lighting

Operation Check

~2min read

OPERATION CHECK

AUTOMATIC HIGH BEAM SYSTEM OPERATION CHECK

(a) Check the operation of the Automatic High Beam indicator light.

*a

Automatic High Beam indicator light

(1) Turn the ignition switch to ON.

(2) Set the light control switch to the AUTO or HEAD position.

(3) Set the high/low beam switch to the HIGH position.

(4) Press the Automatic High Beam switch.

HINT:

If the Automatic High Beam switch is set to ON when the light control switch is not in the HEAD or AUTO position, or the high/low beam switch is not in the HIGH position, the message "To Active Auto High Beam, Switch Headlights to High Beam" is displayed on the multi-information display.

(5) Check that the auto high beam indicator light comes on.

(b) Check the operation of the auto high beam function.

(1) At night, while driving the vehicle with the auto high beam system in standby mode, check whether the high beams come on automatically after a short delay when all of the following conditions are met:

  • The vehicle speed is above approximately 34 km/h.
  • The area in front of the vehicle is dark.
  • There are no oncoming vehicles with their headlights on.
  • There are no preceding vehicles with their taillights on.
  • There are some street lamps along the road.

(2) At night, while driving the vehicle with the high beams activated by the automatic system, make sure the auto high beam system turns off the high beams and returns to standby mode when any of the following conditions is met:

  • The vehicle speed is below approximately 27 km/h.
  • The ambient light level exceeds a specified threshold.
  • There are oncoming vehicles with their headlights on.
  • There are preceding vehicles with their taillights on.
  • The light from street lamps in the vehicle's path exceeds a specified threshold.