Symptom Table
SYMPTOM TROUBLESHOOTING TABLE
NOTICE:
- Before replacing the main body ECU (multiplex network body ECU), refer to the registration section.*1
*1: with Smart Key System
- When replacing the front camera sensor, always replace it with a new part. If a front camera sensor previously installed on another vehicle is used, the information stored in the front camera sensor will not match the vehicle information. As a result, a DTC may be stored.
- If the front camera sensor has been replaced with a new part, be sure to perform front camera sensor learning.
Click here
.gif)
HINT:
Use the table below to determine the cause of the symptoms. If several suspected areas are listed, the possible causes of the symptom are shown in order of probability in the "Suspected Area" column of the table. Check each symptom, verifying the suspected areas in the order listed. Replace parts if necessary.
Auto High Beam SystemSymptom | Suspected Area | Link |
|---|---|---|
The auto high beam indicator light in the combination meter does not come on |
Check the operating conditions |
|
Check the meter and gauge system |
||
Auto High Beam Switch Circuit |
||
High/low beam changeover switch circuit |
||
Combination meter assembly |
||
Front Area Recognition Camera |
||
Main body ECU (multiplex network body ECU) |
||
The auto high beam system does not operate |
Check the operating conditions |
|
Check the Data List (Auto High Beam STS) |
||
Make sure the low beam and high beam operate manually |
- |
|
Check the operation of the automatic light control system |
||
Auto High Beam Switch Circuit |
||
High/low beam changeover switch circuit |
||
Front Camera Sensor Power Supply Circuit |
||
Front Area Recognition Camera |
||
Main body ECU (multiplex network body ECU) |