K114 Continuously Variable Transmission

How to Use Troubleshooting

~3min read

PRECAUTION / NOTICE / HINT

HINT:

  • The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure there is no malfunction in the CAN communication system.
  • *: Use the Techstream.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CUSTOMER PROBLEM ANALYSIS

(a) Refer to the How to Proceed with Troubleshooting section in the Introduction of ECU Controlled Systems.

Click here

NEXT
  1. CHECK BATTERY VOLTAGE

Standard voltage:

11 à 14 V

HINT:

If the voltage is below 11 V, charge or replace the battery before proceeding.

NEXT
  1. CHECK CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check whether the CAN communication system is operating normally.

CAN Bus Check

HINT:

  • Refer to the CAN Bus Check section of the CAN Communication System.

    Click here

  • The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure there is no malfunction in the CAN communication system.

Result:

Result

Proceed to

CAN communication DTCs are not output.

A

CAN communication DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A
  1. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*

(a) Refer to Check / Clear DTCs.

Click here

NEXT
  1. CHECK MODE DIAGNOSIS SETUP*

(a) Refer to the check mode procedure.

Click here

NEXT
  1. CHECK DTCs*

(a) Go to DTC Check / Clear.

Click here

Powertrain > Engine and ECT > Trouble Codes

Result:

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

B

GO TO STEP 14

A
  1. BASIC INSPECTION

(a) Refer to the CVT Fluid section.

Click here

(b) Refer to the Park/Neutral Position Switch item.

Click here

(c) Refer to the Shift Lever item.

Click here

NG

GO TO STEP 11

OK
  1. CONFIRM PROBLEM SYMPTOMS

(a) Refer to the Road Test item.

Click here

(b) Refer to the Mechanical System Tests item.

Click here

(c) Refer to the Hydraulic Test item.

Click here

Result:

Result

Proceed to

Symptom does not occur

A

Symptom occurs

B

B

GO TO STEP 11

A
  1. SIMULATE SYMPTOMS

(a) Refer to Symptom Simulation.

Click here

NEXT
  1. COMPONENT INSPECTION

NEXT
  1. REPAIR OR REPLACEMENT

NEXT
  1. CONFIRMATION TEST

NEXT

END

  1. DTC CHART

(a) Go to the Diagnostic Trouble Code Chart.

Click here

NEXT
  1. CIRCUIT INSPECTION*

NEXT
  1. PROBLEM SYMPTOMS TABLE

NEXT
  1. REPAIR OR REPLACEMENT

NEXT
  1. CONFIRMATION TEST

NEXT

END