K114 Continuously Variable Transmission

Check Mode Procedure

~2min read

CHECK MODE PROCEDURE

DESCRIPTION

(a) Check mode has increased detection sensitivity, allowing it to detect malfunctions that normal mode cannot detect. Check mode can also detect all malfunctions that can be detected in normal mode. In check mode, DTCs are stored based on 1 trip detection logic.

CHECK MODE PROCEDURE

(a) Make sure the following conditions are met:

(1) Battery voltage is 11 V or higher.

(2) The throttle valve is fully closed.

(3) The shift lever is in the P or N position.

(4) The air conditioning is off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn on the Techstream.

(e) Select the following menus: Powertrain / Engine and ECT / Utility / Check Mode.

Powertrain > Engine and ECT > Utility

Check Mode

(f) Check that the MIL flashes as shown in the diagram.

NOTICE:

  • All DTCs and freeze frame data are cleared if: 1) the ECM is switched from normal mode to check mode or vice versa using the Techstream; or 2) the ignition switch is switched from ON to ACC or OFF while in check mode.
  • Before switching to check mode, record the DTCs and freeze frame data.

(g) Start the engine. The MIL should turn off after the engine starts.

(h) Simulate the conditions under which the malfunction occurred as described by the customer.

(i) After simulating the malfunction conditions, check the DTCs and freeze frame data using the Techstream.