K114 Continuously Variable Transmission

Hydraulic Test

~3min read

HYDRAULIC TEST

CAUTION:

  • Do not perform a stall test when anyone or any objects are near the vehicle.
  • The vehicle may move suddenly, which could result in a serious accident.
  • Do not perform a stall test if a wheel chock is not in the correct position.
  • The vehicle may move suddenly, which could result in a serious accident.
  • Do not perform the stall test on a slippery or low-friction surface, as the wheels may slip.
  • The vehicle may move suddenly, which could result in a serious accident.

PERFORM HYDRAULIC TEST

NOTICE:

  • This test must be performed after checking and confirming that the engine is normal.
  • Perform this test when the CVT fluid temperature is between 50 and 100 °C.
  • Perform this test with the air conditioning turned off.
  • Do not perform the stall speed test for more than 5 seconds.
  • When performing the stall speed test more than once, be sure to wait at least 15 seconds between tests.
  • Perform this test with the AUTO function (function associated with gear shifting) of the electronic parking brake system set to OFF.

(a) Measure the secondary oil pressure.

(1) Fully apply the parking brake and chock all 4 wheels.

HINT:

When the Electric Parking Brake Switch Assembly is pulled toward the lock side twice (2 lock operations), the maximum braking force is applied.

(2) Connect the Techstream to the DLC3.

(3) Start the engine.

(4) Turn on the Techstream.

(5) Select the following menus: Powertrain / Engine and ECT / Active Test / Connect the TC and TE1 / Data List / A/T Oil Pressure.

HINT:

Perform the Active Test while observing the A/T Oil Pressure value in the Data List shown on the screen.

Powertrain > Engine and ECT > Active Test

Connect the TC and TE1

(6) Keep the left foot firmly on the brake pedal and move the shift lever to the D position.

(7) Depress the accelerator pedal as far as possible with the right foot. Quickly read the maximum secondary oil pressure reached when the engine speed reaches the stall speed, then immediately release the accelerator pedal.

(8) Keep the left foot firmly on the brake pedal and move the shift lever to the R position.

(9) Depress the accelerator pedal as far as possible with the right foot. Quickly read the maximum secondary oil pressure reached when the engine speed reaches the stall speed, then immediately release the accelerator pedal.

Specified Secondary Oil Pressure

Engine

Shift lever position

Secondary Oil Pressure

3ZR-FAE

D

3.9 to 4.7 MPa

(39.8 to 47.9 kgf/cm2, 566 to 682 psi)

R

3.7 to 4.9 MPa

(37.7 to 50.0 kgf/cm2, 537 to 711 psi)

HINT:

If the secondary oil pressure is above the maximum or falls below the minimum value, a solenoid valve, regulator valve or modulator valve may be faulty.