Fiat Bravo Quiz
Lighting system

Removing and installing tail lamp

In this manual: Lighting system
Dear Reader — 1Engine — 35Engine lubrication — 3Engine cooling — 10Ignition/spark plugs — 14Fuel system — 10Petrol fuel injection — 13Diesel injection system — 13Exhaust system — 7Clutch — 7Transmission / Gearshift / Automatic Transmission — 5Front Axle — 11Rear axle — 4Steering — 9Wheel alignment — 1Brake system — 22Wheels and tyres — 10Body — 34Heating — 6Electrical system — 39Lighting system — 14Instruments — 7Windscreen wiper system — 8Vehicle care / tools — 6Jump Starting / Towing the Vehicle — 3Jacking up the vehicle — 1Fiat Bravo / Brava Maintenance Schedule — 1Maintenance — 38Wiring diagrams — 5
~1min read
010203040502015N·mlb·ft
Tightening torque found on this page
Removal
Heckleuchte aus- und einbauen

  • Remove the center trim panel in the luggage compartment - a -. To do so, unscrew 4 Phillips screws - 1 -, pry out clip -2- with a small screwdriver and unscrew 2 hex socket screws - 3 - SW 7 mm.

Heckleuchte aus- und einbauen

  • Remove side trim panel - b -. To do so, unscrew Phillips screws - 4 - and, on the left-hand panel, pry out clip - 5 - with a small screwdriver.

    The illustration shows the right-hand trim panel of the Bravo.

Heckleuchte aus- und einbauen

  • Bravo: Disconnect multi-pin connector - 6 -.

  • Bravo: Unscrew nuts -arrows- and remove tail lamp towards the outside.

Heckleuchte aus- und einbauen

  • Brava: Disconnect multi-pin connector.

  • Brava: Unscrew screws -arrows- and remove tail lamp towards the inside.

  • Check the seal for tail lamp for porosity or damage; replace if necessary.

Installation

  • Fit tail lamp and tighten screws.

  • Push on multi-pin connector

  • Fit side trim panels first, then center trim panel, and secure with screws. Tighten hex socket screws to 20 N·m.

    Press in clip(s).

Test yourself

A quick Fiat Bravo quiz: every answer comes with an explanation and a link to the manual page.