Installation

PROCEDURE

1. Lubricate the inside of the bushing.
Lubricant: SAE J310, NLGI No. 0

2. Переместите рычаг селектора и переключатель диапазона коробки передач в позицию

2. Move the shift lever and the transaxle range switch to the N position, and connect the shift cable.

3. При подсоединении троса управления коробкой передач перемещайте кронштейн

3. When connecting the transaxle shift cable, move the cable bracket until the cable aligns with the transaxle lever.

4. Установите шайбу и вверните болт и гайку крепления троса.

4. Install the washer, then install and tighten the cable securing bolt and nut.

5. Со стороны рычага селектора установите зажим.

5. Install the clip on the shift lever side.
6. Connect the shift lever position indicator illumination connector, the O/D switch connector, the parking switch connector, and the drive mode select connector.

7. Установите панель управления коробкой передач.

7. Install the gearshift control panel.

8. Нанесите смазку в месте, показанном на рисунке.

8. Apply grease to the location shown in the illustration.

Lubricant: SAE J310, NLGI No. 2

9. Move the shift lever to the N position, then turn the cam plate so that the clearance between the cam plate and the assembly is within specification.
Clearance: 15.2–15.9 mm

Make sure the B side of the lever adjusting cam is facing the button side.

10. Install the O/D switch on the lever knob, then insert the terminals into the switch connector.
11. Install the lever knob and secure it with two screws.

12. Install the center console.

Installation

Test yourself