Hyundai Elantra CN7 Quiz

Ignition switch - ST terminal and starter interlock switch (A/T models)

In this manual: Ignition switch - ST terminal and starter interlock switch (A/T models)
Repair and Maintenance Manual for Hyundai Elantra — 0General Information — 0Engine - Mechanical (DOHC 1.8L/2.0L) — 0Engine - Mechanical (DOHC 1.6L) — 0Engine Electrical Equipment — 0Emission Control System — 0Fuel system — 0Clutch — 0Transmission — 0Wheel Drive Shaft and Axle — 0Suspension — 0Steering — 0
~1min read

ВЫВОД ST И ВЫКЛЮЧАТЕЛЬ БЛОКИРОВКИ СТАРТЕРА (МОДЕЛИ С АКПП)
ST TERMINAL AND STARTER INTERLOCK SWITCH (A/T MODELS)

When the ignition key is turned to the "START" position, battery voltage is supplied through the ST terminal of the ignition switch and the starter interlock switch to the ECM. If the A/T selector lever is in any position other than "P" or "N", battery voltage is NOT supplied to the ECM. Based on this signal, the ECM determines the A/T operating mode and controls the idle air control (ISA) servo to obtain optimal idle speed.


WIRING DIAGRAM - ST TERMINAL AND STARTER INTERLOCK SWITCH (A/T MODELS)

TROUBLESHOOTING HINTS If the starter start signal from the starter interlock switch is incorrect, even though the starter interlock switch harness and the switch itself are normal, check the adjustment of the A/T control cable.


INSPECTION USING HI-SCAN (PRO) TESTER

С ПОМОЩЬЮ ТЕСТЕРА HI-SCAN (PRO)CHECK WITH HI-SCAN (PRO) TESTER

WIRING INSPECTION

Замок зажигания - вывод st (модели с МКПП)

Test yourself

A quick Hyundai Elantra CN7 quiz: every answer comes with an explanation and a link to the manual page.