Engine

Engine Stand Setting

~2min read

Setting

Remove the engine assembly from the vehicle. Refer to Unit Removal & Installation.

Remove the parts that may restrict installation of engine to a widely use engine stand.

  • Fix crankshaft with a ring gear stopper [SST: KV10118600 (NI-48641)], and remove mounting bolts.

  • Loosen mounting bolts in diagonal order.

  • Check for deformation or damage of drive plate.

Lift the engine with hoist to install it onto the widely use engine stand.

  • If the load capacity of the stand is not adequate, remove the following parts beforehand to reduce the potential risk of overturning the stand.

    • Remove intake manifold. Refer to Removal and Installation.

    • Remove fuel injector and fuel tube assembly. Refer to Removal and Installation.

    • Remove ignition coil. Refer to Removal and Installation.

    • Remove rocker cover. Refer to Removal and Installation.

    • Other removable brackets.

Drain engine oil. Refer to Draining.

Drain engine coolant by removing water drain plug from both sides of the cylinder block as shown in the figure.

: Washer
: Plug
: Always replace after every disassembly
: Engine front