Engine
Spark Plug
In this manual: Engine
~2min read
Exploded View
Bank 1 side
| Ignition coil | Spark plug | Rocker cover | |||
| Rocker cover gasket | Blow-by hose 1 (bank 1) | Clamp | |||
| Blow-by hose 2 (bank 1) | Intake camshaft position sensor | Exhaust camshaft position sensor | |||
| Crankcase pressure sensor | |||||
| Comply with the installation procedure when tightening. Refer to Removal and Installation. | Camshaft bracket side | To rocker cover (bank 2). | |||
| To intake manifold. Refer to Exploded View. | |||||
| : N·m (kg-m, ft-lb) | |||||
| : N·m (kg-m, in-lb) | |||||
| : Always replace after every disassembly. | |||||
| : Should be lubricated with oil. | |||||
| : Sealing point | |||||
| : Indicates that the parts is connected at points with same symbols in actual vehicle. | |||||
Bank 2 side
| Oil filler cap | Oil filler tube | O-ring | |||
| Rocker cover gasket | Rocker cover | Spark plug | |||
| Ignition coil | Exhaust camshaft position sensor | Intake camshaft position sensor | |||
| Clamp | Blow-by hose (bank 2) | ||||
| Comply with the installation procedure when tightening. Refer to Removal and Installation. | Camshaft bracket side | To air duct. Refer to Exploded View. | |||
| To rocker cover (bank 1). | |||||
| : N·m (kg-m, ft-lb) | |||||
| : N·m (kg-m, in-lb) | |||||
| : Always replace after every disassembly. | |||||
| : Should be lubricated with oil. | |||||
| : Sealing point | |||||
| : Indicates that the parts is connected at points with same symbols in actual vehicle. | |||||
Removal & Installation
REMOVAL
Remove engine cover. Refer to Removal and Installation.
Remove ignition coil. Refer to Removal and Installation.
Remove spark plug with a spark plug wrench (commercial service tool).

| : 14 mm (0.55 in) |
INSTALLATION
Install in the reverse order of removal.
Inspection
INSPECTION AFTER REMOVAL
Use the standard type spark plug for normal condition.
| Spark plug (Standard type) | : Refer to Spark Plug. |
Was this page helpful?