Engine

High Pressure Fuel Pump and Fuel Hose

~5min read
0102030405026.520N·mlb·ft
Tightening torque found on this page

Exploded View

High pressure fuel pump insulator High pressure fuel pump O-ring
High pressure fuel pump lifter Bracket Holder
Fuel feed hose
To fuel rail (bank 1). Refer to Exploded View. To centralized under-floor piping. Refer to Hydraulic Layout. Comply with the assembly procedure when tightening. Refer to Removal & Installation.
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
: Should be lubricated with oil.

Removal & Installation

REMOVAL

Release fuel pressure. Refer to Work Procedure.

Remove engine cover. Refer to Removal and Installation.

Remove air cleaner cover and air duct. Refer to Removal and Installation.

Remove air inlet tube 1. Refer to Removal & Installation.

Remove intake manifold. Refer to intake manifold : Removal and Installation.

Remove fuel tube (bank 1). Refer to Removal and Installation.

Disconnect high pressure fuel pump harness connector .

Remove high pressure fuel pump insulator .

Disconnect quick connector with the following procedure :

Disconnect fuel feed hose from holder . Disengage and pull up the pawl of the fuel feed hose connector retainer to disconnect the fuel feed hose from high pressure fuel pump.

Remove high pressure fuel pump and lifter.

INSTALLATION

Install high pressure fuel pump according to the following procedure.Check the orientation of pump cam from the mounting area (view arrow) of high pressure fuel pump.

Aim pump cam at the BDC area (arrow position).
: Camshaft (EXH)
Install O-ring to high pressure fuel pump. When handing new O-ring, paying attention to the following caution items: Install high pressure fuel pump lifter. Apply oil to the fitting area of high pressure fuel pump O-ring and camshaft bracket side to install high pressure fuel pump. Install high pressure fuel pump. To prevent damage to high pressure fuel pump and camshaft bracket, the following instructions must be observed.

Connect fuel feed hose with the following procedure, and them install the fuel feed hose.Check no foreign substances are deposited in and around matching pipe and quick connector, and no damage on them. Quick connector shall be inserted gradually, aligning with the axis of the matching pipe. Insert the retainer until it clicks and check the retainer is locked. After insertion, pull the connector and check that the connector is locked.

: Lock position
: Unlock position
After attaching the quick connector and fix the hose to the clamp.

Install in the reverse order of removal after this step.

Inspection

INSPECTION AFTER INSTALLATION

Check for Fuel Leakage

Turn ignition switch “ON” (with the engine stopped). With fuel pressure applied to fuel piping, check that there is no fuel leakage at connection points.

Start the engine. With engine speed increased, check again that there is no fuel leakage at connection points.