Piston
Piston
DESCRIPTION
| Selection points | Selection parts | Selection items | Selection methods |
|---|---|---|---|
| Between cylinder block and crankshaft | Main bearing | Main bearing grade (bearing thickness) |
Determined by match of cylinder block bearing housing grade (inner diameter of housing) and crankshaft journal grade (outer diameter of journal) |
| Between crankshaft and connecting rod | Connecting rod bearing | Connecting rod bearing grade (bearing thickness) | Combining service grades for connecting rod big end diameter and crankshaft pin outer diameter determine connecting rod bearing selection. |
| Between piston and connecting rod | — | — | — |
The identification grade stamped on each part is the grade for the dimension measured in new condition. This grade cannot apply to reused parts.
For reused or repaired parts, measure the dimension accurately. Determine the grade by comparing the measurement with the values of each selection table.
For details of the measurement method of each part, the reuse standards and the selection method of the selective fitting parts, refer to the text.
WHEN CYLINDER BLOCK IS REUSED
Measure the cylinder bore inner diameter. Refer to Inspection.
Determine the bore grade by comparing the measurement with the values under the cylinder bore inner diameter of the “PISTON SELECTION TABLE”.

| : Front mark | |
| : Two dimensional code |
Select piston of the same grade.
PISTON SELECTION TABLE
Unit: mm (in)
| Engine bank | Bank1 | Bank2 |
|---|---|---|
| Cylinder bore inner diameter | 86.000 - 86.015 (3.3858 - 3.3864) |
86.000 - 86.015 (3.3858 - 3.3864) |
| Piston skirt diameter | 85.965 - 85.980 (3.3844 -3.3850) |
85.965 - 85.980 (3.3844 - 3.3850) |